Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for December 21, 2008
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
1986 Ford Ranger STX 2.9L Hesitation, Surge VIN: 1FTCR11T9G
please help! under light acceleration the truck hesitates and starts to buck. almost seems like secondary ignition. already replaced cap, rotor,plugs, wires, pcv ect. no check engine light. did scan for codes none found. did adaptive stratagy but didn't seem t...
2000 Ford F-250 Super Duty XL 7.3L convertor VIN: 1FTNW20E2Y
Trans worked fine and splines on the input shaft in the convertor stripped. If install a new convertor and input shaft will I be good to go? Has anybody seen anything like this before?
2001 Ford Ranger XL 2.5L crank bolt VIN: 1TTYR10CX1
Hi All This should be a no brainer, but here I am. Thanks in advance for taking time to look at this. Anyway this ranger came in with a miss. determined burnt valve. tried to remove crank bolt so I can change timing belt while down. I have tried my 1/2 inch ...

Fixes & Summaries for Ford
Fix/Summary Answers
2003 Ford Expedition Eddie Bauer 5.4L Misfire, MIL Lamp on VIN: 1FMPU18L53
Thanks, Found the heater hoses leaking! that must of been why she would leave here ok and then that afternoon or the next day same problem again, I replaced the hoses and the clamps eveything looks good for now... Thanks !!!
2001 Mercury Cougar 2.5L No Start VIN: 1ZWFT61LO1
thanks to all the turned out to be the pcm. driver for coils was bad. Trouble codes: P0171, P0304.
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next