× Auto Repair Pros Member Benefits TechHelp Knowledge Base Forums Resources My iATN Marketplace Chat Pricing About Us Join Industry Sponsors Video Members Only Repair Shops Auto Pro Careers Auto Pro Reviews
Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for November 1, 2008
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
1999 Dodge Ram 3500 Van 5.9L No Start VIN: 2B7KB31Z7X
Hey Everyone, I Have This 1999 Dodge Ram Van Here That Was Towed In As A No Start. While Trying To Start I Noticed Dash Odometer Says NO BUS.I Tried Putting My Modis On And It Said No Comunication.So I Started By Checking Powers & Grounds To PCM And Found That...
1999 Dodge Durango 5.2L Convertor VIN: 1B4H528Y7X
This vehicle was brought to me from a long time customer. I am not a transmission specialist but the customer insisted on me working on the vehicle. The vehicle came in with a concern of a transmission fluid leak and vehicle stalls when put in reverse, but onl...
2000 Dodge Grand Caravan SE 3.3L torque conv lockup VIN: 1B4GP44G1Y
i have one for dodge people, this dodge caravan came in with the mil on and i pulled code p0740 tcc operation fault. fluid is full and good in color ,upon test drive i had cleared the code and noticed that at about 50 to 60 mph the tcc would only go to partial...
2002 Dodge Neon ES 2.0L MIL Lamp on, SPEEDOMETER NOWORK VIN: 1C3ES46C62
this vehicle came speedometer does not work. scan it got p0500, test drive no speed reading on scanner. take both the out put and input speed sensor out. test the resisstence compare with new sensor, they are similer. mitchell trans wiring there is third vss w... Trouble codes: P0500 (novehicle speed sensor signal)
1997 Jeep Grand Cherokee Laredo 4.0L 1st gear VIN: 1J4GZ58S5V
trans seems to be stuck in 1st gear all the time. no matter what position the shifter is in the scanner reads 1st gear & it is in 1st even in reverse (trans binds in reverse). the position p/r/n/od/2/1 read correctly on scanner. no codes stored. any ideas.
2000 Jeep Grand Cherokee Limited 4.7L blend door VIN: 1J4GW58N2Y
Hello, I'm removing the ac/heater box to repair blend door failure. I got the front dash section off. I am working on removing dash frame to access a/c box. I've got every bolt out I can see but cannot remove it. It seems like something close to the middle is...
2004 Jeep Grand Cherokee Limited 4.7L atc VIN: 1J8GW58N74
Set the temp on both sides @ 77 degrees, floor/vent position, fan about 1/4 of the way up.(this is how I verified the problem but can happen at other settings) After a short drive, 1 of the sides will start blowing cool/cold air, the other side will be fine. A...

Fixes & Summaries for Chrysler
Fix/Summary Answers
2001 Chrysler 300M 3.5L No Start, Stall VIN: 2C3HE66G01
As many have stated, the skim module needed to be changed but this did not fix the problem. It is still doing the same thing: starts and dies after running about 5 seconds...when it starts and dies, there is no tach signal but when it starts and runs, immedia...
2002 Chrysler PT Cruiser 2.4L Hesitation, Surge VIN: 3C4FY48B32
Thanks to everyone who take time to anwser me ,the problem was the crank sensor and the cam sensor i removed it and cleaned it whit the cam and crankand since this time the car is ok ,so monday i will change this 2 sensors.Thanks again. Trouble codes: P0300.
2005 Chrysler Town & Country LX 3.8L battery draw VIN: 2D4GP44L65
Thank you for the responses, most told about MIC's and BCM's being the problem childs. The customer had extended warranty which was for Chry dealers only. Local dealer already had numerous times and said no problem or bad battery, gave customer print of draw f...
2000 Dodge Stratus ES 2.5L ignition lock cylinder VIN: 1B3EJ56H8Y
I love you guys. Almost all of you said to tap on the key to move the tumblers. I did it and it worked, so monday I'll be replacing the tumbler. Thank you for all the quick responses. Doug
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next