|
|
2006 Lexus IS 250 2.5L TPM Initialization
Changed a wheel and tire pressure sensor on this one, stock
from Lexus dealer. Couldn't get light off, had one code
stating that the sensors were not programmed. Went in with
Vetronix Mastertech w/OE software (Toyota "Intelligent"
Tester), found that none of t... |
View |
|
1992 Mazda MPV 3.0L No Start, Poor Idle Quality
Thanks in advance for any help with this problem! After
driving for opprox 1/2 hour & letting van sit for 20 min it
is hard to restart, idles very low (2-300 rpm) & stalls. If
carb cleaner is sprayed in the intake it will stay running.
Fuel pressure is 38 psi,... |
View |
|
1992 Toyota MR2 2.2L No Start
hello toyota techs please i need help with this one please
like i say toyota dealership replace ignition
coil,igniter,cap and rotor. they told me i have to replace
wiring harness and distribuitor i did it 2 days ago and i
don't see any changes check ecm and te... |
View |
|
2002 Toyota Tacoma 2.7L No Start
Our customer says that when engine light is on & they
refill gas the truck will start hard w/ exteneded
cranking.We tested for EVAP leaks & system
condition,everything looked good.We also replaced canister
& solenoid with still having the same code & symptom
r... Trouble codes: PO441 (EVAP Purge problem). |
View |
|
1992 Honda Accord 2.2L cv joint noise
A big thank you to all of those who responded with help on this one. As we all suspected, I got ahold of a bad axle. Replaced both axles with new ones. That took care of the noise. Have not heard from customer in two weeks. |
36 |
|
2008 Honda Accord 3.0L Day Time Running Lights
I thought about the idea given to me about putting a resistor in the circuit to keep the daytime running lights from affecting the HID lights, but was not comfortable with it. The resistor could fail down the line and cause some damage to a car that's only 2 m... |
3 |
|
2002 Mitsubishi Eclipse 3.0L Poor Idle Quality, Hesitation, Surge, Cuts out, Stall, Misfire, MIL Lamp on
well reflashing pcm did not do anything, Fuel pmp was a problem when it would get hot it lost preshure by the time i would hook it up it would cool off enouth to work again. could not leave it hooked up to test preshure it was pain in the ____ to test it i had... Trouble codes: p0171 (bank 1 too lean), p0174 (bank 2 too lean), p0300 (random cyl miss). |
4 |
|
2001 Nissan Pathfinder 3.5L Hesitation, Misfire, MIL Lamp on
While I can't call this one closed, I'm fairly sure coils are the culprit. The dealer wants to replace as a set for some stratospheric amount and the customer is freaking. At least I'm only the semi-bad guy since I only sold the signal coil. She also added the... Trouble codes: PO300 (Random misfire), PO430 (Cat efficiency low bank 2), PO1320 (Primary ign signal failure to ECM). |
15 |
|
Prev
