|
1998 Chrysler Sebring 2.5L No start Car towed in. No start floods plugs right away. Has strong
spark and good compression stores no codes. If you pull the
fuel pump relay and crank on it enough it will finally
start but runs bad hesitates extremely rich. Timing belt
and marks are all ok. Disconn... |
View |
|
2002 Chrysler Town & Country 3.8L engine replacement Hi guy's, I have a 2002 chrysler t&c that I'm going to be
replaceing the motor with a used one on monday, according
to mitchell your suppose to take it out the bottom, looking
at it I'm wondering if I could remove the wiper assembly
and take it through the top... |
View |
|
1996 Dodge Ram Van 3.9L MIL Lamp on good day gentalmen,this van originally camin for LOF. clean
bat. cables and the c.e.lite on;was and is running good
idle and highway; checked for codes none and the lite was
not on when the van was driven into the stall. took care
othe other items and requeste... Trouble codes: P1391 (Loss of cam or crank signal). |
View |
|
1999 Dodge Durango 5.9L Differential The front differential blows the fluid out the vent even
though it has Chrysler's "fix" for this problem. I went
through it again and got all within specs with new bearings
and seals and put synthetic fluid in it this time. Drove it
in 4wd about 1/2 hour and i... |
View |
|
2001 Dodge Pickup 5.9L cranking we have a dodge truck that we install a reman engine in.
we now have a noise from starter. this happens when you
crank the truck to start, once the truck starts and you
release the key, you hear a clagging sound. sounds like a
start trying to engage. on inspec... |
View |
|
2004 Jeep Grand Cherokee 4.0L No Start VEHICLE CAME IN FOR A NO START, WE SCANNED FOR CODES AND
FOUND THAT THE SCAN TOOL COULD NOT COMMUNICATE WITH ECM.
FOUND THAT WE HAD NO SPARK AND THAT ALL SENSOR REFERENCE
VOLTAGES WERE AT 4.2 VOLTS. AFTER MUCH DIGGING, WE FOUND
THAT THE ASD RELAY WAS NOT CLOSI... |
View |
|
1998 Plymouth Neon 2.0L speedodometer Can not find any dia info on speedodometer. speedodometer
is inop. scanner shows speed but doesnt show on inst.
cluster. Have taken out vss, inspect for stripped gear. No
damage. Any dodge techs, please give me some insight on
these circuit. |
View |