|
1994 Chevrolet S10 Pickup 4.3L No Start Vehicle has no injector pulse width cold. Replaced fuel
pump, processor, tbi assembly, and pick up coil. With
injectors unplugged has pulse width when plugged back in
loses pulse width. Voltaged dropped grounds and power at
processor no problem found. Checked ... |
View |
|
1999 Chevrolet Pickup 6.5L 1-2 shift well it all stated over a mud dabber laying a nest in the
trans vent hose and thr trans cooked, well had to replace
the trans with a rebuilt and after a week it came back with
a trans code of p0759 siliniod b was not working propertly.
replaced this and test d... |
View |
|
1996 GMC Suburban 6.5L No Start, Stall This is my dads truck. While driving he told me truck dies
and then restarts.Every time he drops truck off i can't
duplicate problem.The truck runs fine untill tonight.I had
a mac mentor on it tonight and it died out on me.As soon as
it died the engine light w... |
View |
|
1997 GMC Pickup 6.5L No Start, Stall My brother in law just purchased this truck. The problem is
it dies while driving and at a idle just like someone
turned off the key. Sometimes it will re start sometimes it
won’t even try to start. I can drive it for a couple days
with no problems and some da... |
View |
|
2003 GMC Envoy XL 5.3L front axle 4x4 lock When shifting into 4x4 the lights come on, the front drive
shaft turns, but the front axle does not engage. If the
actuator is removed and the lock up is pushed in with a
tool, there is no forward engagment, but it seems to engage
in reverse. Any ideas? |
View |
|
2002 Pontiac Grand Prix 3.8L Pulley Noise This Grand Prix came in with bearing type noise inside the
cab at idle (in or out of gear). When the car is throttled
rapidly the noise goes away for about a second. We tried to
locate the source under the hood but could'nt realy tell
what was causing it. We p... |
View |
|
1997 Saturn SL2 1.9L No start Saturn runs fine until at operating temperature then starts
to sputter and dies. Will not restart untill cooled off. At
time of No start confirmed no tach signal and show a cam
sensor code and an egr code which i have also been fighting
with. Is it safe to say... |
View |