|
|
1987 Ford F-150 4.9L Fuel gage
Hello fellow Aitn members i am have had this vehicle in my
shop for a week and continue having problems... can anyone
help?... The Fuel sending unit is shifting back and forth
when vehicle is moving/ driving especially when coming to a
stop. Both sending units... |
View |
|
1997 Ford F-250 7.3L Cuts out, Stall
hey guys, this diesel came in with extreme lack of
maintenance, we found the fuel filter plugged, and running
rough, we serviced the vehicle, new fuel filter and cleaned
the injectors, oil change, also scanned, no codes, checked
the inj. harness, etc. what hap... |
View |
|
1998 Ford F-150 4.6L MIL Lamp on
Hello all. I have this pick up with p0171 and p0174 lean
codes for both bank 1 & 2. When I smoke test I found a leak
at the EGR. The smoke was coming out the vent holes under
the diaphragm. Is this a common thing? |
View |
|
1999 Ford Windstar 3.8L Power Train Control Modlule
The customer complains no start. Started one morning it
stumbled, smoothed out, then quit, been no start since. The
PCM will not comunicate other computer will. Turn the key
on and the theft light will begin flashing quickly. Further
inspections have found tha... |
View |
|
2000 Ford Taurus 3.0L MIL Lamp on
first visit. customer arrived with c.e.l on no driveability
sypmtoms. retrieved dtc's po174 and po171. lean codes.
smoke test found bad pcv hose assembly. replaced. noticed
fuel filter old, replace for maintenance reasons being it
was related. cleaned mass air... Trouble codes: P0174, P0171. |
View |
|
2000 Ford F-150 5.4L Cylinder Head
We are looking at removing the right side cylinder head to
remove a failed spark plug repair insert that has fallen
into cylinder #4. The first step in alldata is to remove
the engine. Book time is 17-20 hrs to do this. We have
heard of techs lifting the cab o... |
View |
|
2002 Ford Taurus 3.0L Misfire, MIL Lamp on
vehicle has a very slight miss fire at start up for only a
couple seconds then smooths out. cylinders 3 and 4 have a
very weak spark at the time compared to all others. i
scoped out primary circuit and the wave pattern at ignition
coil for cyl #4 and#3 does no... Trouble codes: p0352 (ignition coil A thru J primarysecondary circuit malfuntion). |
View |
|
2003 Ford Econoline 7.3L Starting
need some help from diesel ford techs customer is
complaining of dead battery after sitting so i need to know
how to properly check for battery draw on this system with
duel batterys i know you have to check with amp meter i
staying between 200 and 300 milliam... |
View |
|
2004 Ford E-350 Club Wagon 5.4L none
This vehicle has become the bane of my existence, The
symptom is, when hard braking at slow speeds (i.e. coming
to a stop sign), I have a strong pull to the right. It is
such that if you let go of the steering wheel while
braking, the wheel will turn almost 18... |
View |
|
1990 Ford F-250 5.8L Poor Idle Quality, Poor Fuel Economy
thanks all for the info. dealer did not know anything about this until i provided part numbers. if it wasnt for you good people i never would have been able to find these add on check valves and fix the vehicle. there is no switching valve as some suggested on... |
18 |
|
1996 Ford E-150 Econoline 4.9L MIL Lamp on
for starters this truck is not fixed,due to time limits on post i have to close this at this time,what has happened so far,i monitored amp load on pin 91 with amp probe,the reading was .990 while code sets,the scantool at that time shows .o2amps.i then figured... Trouble codes: p0141. |
9 |
|
1998 Ford Taurus 3.0L convertor
THANKS TO ALL THAT REPLIED WENT AHEAD AND CHANGED PCM. VEHICLE SEEMS TO BE OPERATING CORRECTLY THUS FAR. DETERMINED PCM WAS PROBLEM AFTER READING REPLIES AGAIN THANKS |
6 |
|
2002 Ford Ranger 4.0L lifters
got it fixed. thanks to Shannon, James and Dave for their time. replies siad look for restriction in oil galley. problem was lack of restriction to tensioner not allowing lifters to pump up. with intake removed there's a little plug next to tensioner. got hard... |
3 |
|
2003 Ford Focus 2.0L Air bag light
Well I think this one is going to the dealer. I hate to even say that. I also forgot to mention that at this point there are no codes when I scan the computer with my motis. It seems like there is a problem with the control module and it might need to be repla... |
6 |
|
2003 Ford Expedition 4.6L pats, crank no start
HI: New ecm repaired the truck, have to send it to dealer to flash VID. On old control unit where connector 175b plugs in ecm there is internal problem with pins, pushing on connector will disable theft light from blinking with ignition off. I got four repli... |
5 |
|
Prev
