 Prev |
Professional Automotive Repair Technical Discussions for August 24, 2007 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 1999 Chrysler Sebring 2.5L engine VIN: 3C3EL454HX Car was towed in a week ago due to a crank/no start,when I attempted to start the vehicle it cranked immediately.During the next couple days I started it every hour to attempt to duplicate the customers complaint.I finally did get it to act up on one occasion.... |
View | |
| 1997 Dodge Dakota 3.9L Stall VIN: 1B7GG26X2V vehical came in with a very bad misfire engine poping and backfire and with a stall. found and repaired large vacuum leak, cracked distributor, engine now runs fine but will still stall warm or cold fuel pressure stays at 50 lbs. acts like just turned off key ... Trouble codes: 43 (coil 1) |
View | |
| 2000 Dodge Dakota SLT 4.7L Poor Idle Quality, Surge, Cuts out, Stall VIN: 1B7GG2AN0Y This truck came to us with rough idle concern does not matter wether cold or hot condition, when at idle truck feels like cylinder is slightly not firing right or vaccum leak, or weak coil or something to that nature, this problem is when you come from a compl... |
View | |
| 1997 Plymouth Voyager 3.3L insterment cluster VIN: 2P4GP25R9V Customer brought in van with 3 complaints, problem with wipers cycling by them self intermitantly,tach dropping out once in a while, and dieing 3 times at lower speeds,but started right up. I checked the archives and found two main problems with the wipers.upd... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 1998 Chrysler Sebring LXi 2.5L Steering VIN: 4C3AU52N4W Sorry about the wait guys. I had driven this car another 45 miles without duplicating the concern. I then had to contact customer and come to an agreement that it would have to become more pronounced before I can perform a thorough diagnosis. Thanks for all th... |
4 | |
| 2003 Chrysler PT Cruiser Touring 2.4L MIL Lamp on, INTER NO START VIN: 3C4FY58B43 HEY THANKS RICK FROM PENNSYLVANIA AND ALL WHO REPIIED.I REMOVED NEW THE BROG WARNNER CAM SENSOR AND INSTALLED A MOPAR PART AND THAT DID THE TRICK.IATN REALLY HELPED IN ABOUT 12 HOURS THINGS WHERE BACK IN THE GOOD. THANKS TO ALL. BOB Trouble codes: P0344. |
3 | |
| 2000 Dodge Ram 1500 Van 5.2L No Start, Stall VIN: 2B6HB11Y0Y thanks for your replies, after 350 miles of driving i was able to get vehicle to stall.referance voltage to crank,cam,t.p.s., & map sensor was 2.3 volts instead of 5 volts,disconnected all sensor involved & still 2.3 volts. replaced p.c.m. & crank sensor with ... |
4 | |
| 2004 Dodge Stratus SXT 2.4L convertor VIN: 1B3EL36X44 While nobody hit the nail on the head it stiil is ahuge boost to your confidence knowing there is so much support. I finally fixed this thing and all that was wrong was a stuck t/c control valve in valve body not allowing torque converter to fill with oil. Th... |
3 | |
| 1996 Jeep Cherokee Classic 4.0L Poor Idle Quality, Stall, MIL Lamp on VIN: 1J4FJ68S5T Thanks to all that replied. Replacing the TPS fixed the problem. Unhooking the clockspring and the trany module did not help and a tps is alot cheaper than a pcm. Thanks Again. Trouble codes: P0121 (TPS Does not agree with map). |
3 | |
| 1997 Jeep Cherokee Country 4.0L engine VIN: IJ4FJ2857V All replies indicated cam bearings, customer decided to test new hidraulic tapets, same result pressure goes down, Further inspection revealed hole in block behind camshaft gear, so a crack can be present in others area of the block, we will replac... |
9 | |
| 2001 Jeep Grand Cherokee Limited 4.7L MIL Lamp on VIN: 1J4GW58NX1 We decided to replace the cam tone ring with the one off of the old engine and discovered that the new one was dented. It was not visible unless it was turned just right. It now runs great without the light coming on. Thanks to all who responded. It was a lot ... Trouble codes: P1391 (Int loss of CMP AND/OR CKP sensor.). |
4 |
