|
|
1973 Chrysler Imperial 440CID Compressor
Im helping a buddy of mine with this car. When he purchased
the car the A/C didnt work. He replaced the dryer, hoses
and put in R-134A. The A/C worked great for about two
weeks. Then the compressor locked up. He got a new
compressor and now wants to know what ... |
View |
|
2001 Chrysler Concorde 2.7L Charging
this car has a code po622 for chareing circuit not changing
. we have installed a new altenator and this has not fixed
proublem. we have ohms wirs from pcm to alt and they are
good. computer shows that it is field the alternator but it
is not chargeing and bat... |
View |
|
1998 Dodge Avenger 2.0L Stall
this vehicle has been a problem. when the car runs for 10
seconds it stalls. wait for ten minutes and then it starts
and runs for 10 seconds and stalls. we replaced crank
sensor with no change. when car dies it looses spark and
injector pulse. we think its rel... |
View |
|
1998 Dodge Caravan 3.3L No Start
This vehical first came to our shop not running right, it
had little power. The owner decided to change the timing
belt but put it on wrong and bent the valves. So the heads
were taken off and replaced, after this the engine would
not start. They brought it to... |
View |
|
2000 Dodge Grand Caravan 3.8L Windshield Wipers
This van came in with the intermittent wipers not working
at all. We performed the test according to Chrysler's
diagnostics. We used our Genisys to read the intermittent
voltage at all positions of the multifunction switch. The
voltage changed at each position... |
View |
|
2002 Dodge Grand Caravan 3.3L brake system
intermittent lost of brake pedal--one inch from floor==on
highway driving at approx. 120kms per hour===customer goes
to stop the pedal goes to about one inch from floor===brake
fluid is filled in master cylinder=has happened twice in
two weeks on the highway o... |
View |
|
2003 Dodge Ram 3500 Truck 5.9L Poor Idle Quality, Hesitation, Surge, Cuts out, Stall
Look'n for help from all you dodge diesel guys out there.
We don't work on them if we don't have to but this is for a
buddy of mine who's run out of ideas, and unfortunatly I'm
not much help on diesels. All below problems where present
before installing a afte... |
View |
|
2000 Jeep Grand Cherokee 4.0L Misfire
Hello All, This Jeep will run rich most all the time. I
replaced the o2 and drove it. First time out the o2 would
switch just fine, on the return trip it would read rich and
stay there most of the time. The down stream o2 reads
consistantly low. There is a com... |
View |
|
2004 Jeep Grand Cherokee 4.7L No Start
Vehicle came in as a no start. Computer has no
communication with Snap-On Modis. Dashboard does not
respond to ignition being turned on. (E.G. Fuel guage,
voltage meter, ETC.) In Troublshooter under no start was a
description that the crank sensor can short ou... |
View |
|
2005 Jeep Grand Cherokee 5.7L Hesitation, MIL Lamp on
This car shows (on the Starscan) a constant missfire on
cylinder 2&3, random missfires on the other cylinders. This
engine runs smooth and has plenty of power. The car
also-seems like mostly during warmup-buck. This is when the
code p0339 is set. The p0335 and... Trouble codes: p0300 (multiple cylinder missfire), p0339 (crank sensorintermittant), p0315 (no crank sensor learned), p0335 (crank sensor circuit), 1417 (cylinder 7 reactivation control performance). |
View |
|
1997 Chrysler Cirrus 2.5L Hesitation, Surge, Misfire
After re checking everything, we changed the distributer. thanks to all for the responce, most thanks to Jeffrey [...] who pointed out the frequency of failure of this particular unit! |
4 |
|
1997 Chrysler Sebring 2.5L run-on after key off
problem solved: i accidentally found insulation skinned back on alternator harness 3 or 4 inches behind alt connector(hidden beneath harness tape). green/orange wire had some incidental contact with green wire. one is batt+, other is switched power. that is mo... |
6 |
|
2001 Chrysler 300M 3.5L MIL Lamp on
i was out town just got back every body was my diag. wrong i replaced the other02 sensor and now the problem is gone thanks everybody Trouble codes: p0161. |
8 |
|
2001 Chrysler Sebring 3.0L MIL Lamp on
Thanks for the help guys you were correct the Pickup in the Distributer on the old one has one blade,the new engine has three.thanks again for all of your help.
Trouble codes: p0340 (CMP sensor A circiut Malfunction), P0335 (CKP sensor A circiut Malfunction). |
3 |
|
1999 Dodge Ram 1500 Van 5.2L Stall
Hello Fellow Techs,
Thank you everyone who replied to my email. Chad [...] hit it on the head. He had an engineering diagram that showed him that the power lead went through the PCM and powered a number of things, one of them the alternator. He suggested unpl... |
6 |
|
1999 Dodge Ram 1500 Van 5.9L No Start, Poor Idle Quality, Stall
Replacement of the battery (it would pass load test) and reseting bace idle and reseting TPS and IAC with scanner was the fix. Now IAC is at 27 counts.TPS and MIN TPS are at 0.65v. Starting and idle are fine and truck has not been back. I also found a TSB for... |
4 |
|
2003 Jeep Liberty 3.7L Misfire, MIL Lamp on
This one is fixed...all it took was to disconect the battery for 5 mins and all the crazy misfires went away i had cleared the codes with the scanner but still had the crazy readings i guess there is nothing like killing the power and have the pcm come to lif... Trouble codes: 300 (random misfire), 301, thr0ugh, 306 (testing and results). |
5 |
|
1996 Plymouth Breeze 2.0L No Start, Stall, MIL Lamp on
Hello again, and thanks to those who responded. The responses centered around burnt wiring to the crank sensor which I did not have, and checking the coil which I had already replaced, and checking the cam and crank sensors, checked them with vantage and coul... Trouble codes: p0351 (ignition coil circuit). |
5 |
|
Prev
