|
|
2000 Dodge Caravan 3.3L All gages
After brake repair took vehicle on test drive and first
notice ABS light was on dash. After looking further noticed
all gages were not working. Gages would come back on
intermittently and ABS light goes off when gages come back.
After further test driving test... |
View |
|
2001 Dodge Dakota 4.7L Hesitation, Cuts out
Hi techs! This Dodge is turning me grey. When driving down
the road it will momentarily lose power when a bump in the
road is encountered. One can predict exactly when it will
happen as a bump is hit. All grounds have been checked.
Data stream looks good-no co... |
View |
|
2003 Dodge Pickup 4.7L Intermitent no upshift.
Hey. This truck has an intermittent no upshift. Starts and
takes off in second gear. Doesn't change unless u turn the
truck off and start it up again then it will be fine. 2
codes in it, P0875 and P0876. Have driven it a couple times
and has not acted up for u... |
View |
|
2004 Dodge Pickup 4.7L Misfire, MIL Lamp on
ok this one is eating my lunch. the truck came in with
check engine light on for misfire on number 2 cyl. and a
genral misfire code p0300. i pulled the plug out and it was
the oem plug so a chaged all 8 and put in a new coil on
number 2. drove the truck with n... Trouble codes: p0300 (misfire), p0302 (misfire cyl 2). |
View |
|
1987 Jeep Wrangler 2.5L Hesitation, Cuts out
Customer brought in vehicle after the customer did a
tune-up. Checked tune-up and it was done properly. Put on
ignition scope and system looks good. Vehicle hesistates
under wide open throttle. Gas sprays out of the throttle
body. the compression is good. Can'... |
View |
|
1994 Jeep Cherokee 4.0L Hesitation, Cuts out
I'm posting this for a friend.
This Jeep has been in the shop for a month now. When
accelerating fairly hard from a stop the engine bucks like
mad for a few seconds and the carries on like normal. It
will not do it if you load the engine against the brakes.
T... |
View |
|
1999 Jeep Cherokee 4.0L MIL Lamp on
This vehicle came in with DTC P0123 (TPS voltage too high)
and P0121 (TPS does not agree with MAP) The voltage at the
TPS was high at 2.53. This was both in the PCM as well as
at the TPS output terminal. A replacement TPS was installed
with the results being a... Trouble codes: P0123 (TPS voltage too high), P0121 (TPS does not agree with MAP). |
View |
|
1999 Jeep Wrangler 2.5L Poor Idle Quality, Surge, Cuts out, Misfire
99 Jeep Wrangler 2.5L 5 speed 61,000 miles customer states
started bucking and missing intermittently about 2 weeks
ago. He states if riding along easily light to moderate
throttle that truck runs good, but if he accelerates past
half throttle at times it buck... Trouble codes: P0203 (Injector circuit cylinder 3), P0122 (TPS signal low). |
View |
|
2000 Jeep Cherokee 4.0L comp
Thanks in advance. I have this Jeep that has an a/c
problem. The compressor had a bad clutch 6 months ago.
Replaced compressor, drier & orifice tube. Worked great for
6 months. Now it's here with no cold output. Recharged to
check but had all refrig. in system... |
View |
|
2004 Jeep Grand Cherokee 4.0L Cuts out, MIL Lamp on
vehicle at times stalls out but starts right up. recently
r/r spark plugs. however 2 codes for the tps 1 voltage high
2 voltage low always show up.i plan on r/r tps sensor
anyway. are there any othe culprits in this concern like
the ignition coils or something... |
View |
|
1995 Dodge Neon 2.0L master cylinder
Finally got proper proportioning valves from dealer after waiting on backorder proper ones to come in. First ones they sent were for vehicle with abs, second set worked ok but had nothing to do with color code, so alldata data on going by color stripe is not a... |
3 |
|
1996 Dodge Caravan 2.4L Misfire
You know guys, we checked everything on this vehicle, after I had several responses from you about the spark plug cables we looked at them again and found nothing they where one month old but we decided to take a chance and changed them. Thank you guys for the... |
8 |
|
1997 Dodge Grand Caravan 3.3L Will not shut off
Many thanks to those that answered and offered help. I ended up removing everything from from the A21 ignition circuit except the ignition switch, junction block (w/PTC#1) and the PCM. Vehicle would run anywhere from 30 seconds up after key was turned off. ... Trouble codes: P1799 (TCM code - calculated oil temp in use.), P1792 (TCM code - battery disconnected). |
12 |
|
1999 Dodge Pickup 5.2L Excessive Emissions, No Start, Poor Idle Quality, Stall
MIKE FROM MASS SAVED ME THANKS TO ALL THE COIL WAS WORKING BUT APPARENTLY NOT HOT ENOUGH INSTALLED NEW ONE AND VEH STARTED FINE HAD AN ACCEL COIL THAT APPEARED NOT TOO OLD AND I JUST OVER LOOKED IT WOULD HAVE NEVER BET ON THAT I 1 MILLION YEARS |
5 |
|
1999 Dodge Ram Van 3.9L Misfire, MIL Lamp on
Thank you for your responses. We received seven replies. We inspected the intake and that was OK. We check spark plugs and they were OK. With that many recommended sticking valves/carbon build up. We then performed an air induction service and added a fuel... |
7 |
|
2001 Dodge Grand Caravan 3.3L a/c
Thanks for all the great advice. Considering the mileage of the vehicle the customer has opted to go after the dealer to resolve the 'known problem' Thanks again for all the advice. |
17 |
|
2001 Dodge Pickup 5.9L 1-2 shift
I replaced the Gov sensor and solenoid as many suggested, along with filter while in there, adjusted TV cable back to factory specs and it still won't shift out of first, just bounces off the rev limiter. Gov sensor voltage is still .45V, not sure why that is... |
6 |
|
2003 Dodge Pickup 5.7L MIL Lamp on
Well thanks for all your help. From what I gather it is really difficult to check the NVLD pump without a DRBIII. So we ordered up a new pump from Chrysler and so far the truck has yet to return. Thanks again to all of you who took the time to respond. Trouble codes: P0440 (evap sytem failure), P0441 (Purge system performance). |
8 |
|
2007 Dodge Magnum 6.1L clutch plate chatter?
Vehicle was returned to dealer where they didn't find any fault codes but did reflash TCM to latest version and all seems well.
Fluid level on these is measured with a "service dipstick" which has the end graduated in millimeters. To check- you are to hook u... |
5 |
|
Prev
