|Prev||Professional Automotive Repair Technical Discussions for July 28, 2007
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Asian
|1999 Honda Civic EX 1.6L srs VIN: 1HGEJ8244X
Alldata says the srs check connector is in the right kick panel glove box area, can't find it. I found the erase connector, no problem and I found a post here for jumping the 4 and 9 pins on the ALDL, tried that but that didn't work. can someone please tell me...
|1995 Mitsubishi 3000GT 3.0L Unknown VIN: JA3AM84JXS
This vehicle was brought to me on a wrecker. No forward or reverse gears. The fluid was full but BLACK!! I am no means a transmission expert, I know enough to pass the test. I figure it needs a transmission. The customer supplied me with a "used" transmission...
Fixes & Summaries for Asian
|1995 Nissan Maxima GLE 3.0L Hesitation, Cuts out, Stall, MIL Lamp on VIN: JN1CA21D4S
Ok it was the ECM it appeared wet under console from stoped up AC drain tube, replaced with working used unit and could then pull the same code (34 - knock sensor) from all three places (OBD II, Nis2 beside fuse panel and by turning screw on ECM). Checked knoc... Trouble codes: P0325 (knock sensor).
|2000 Toyota Corolla CE 1.8L Hesitation, Surge, Cuts out, Stall VIN: 2T1BR12EE0
hello and thanks again to everyone that replied. Most of you sugested to clean the maf sensor. I did just that and the car runs like a top. I had cleaned it before but did not realize the heat wire diode was up in the unit. I cleaned a little bulb looking diod... Trouble codes: P0172 (bank one rich).