|Prev||Professional Automotive Repair Technical Discussions for July 4, 2007
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1994 Chrysler Concorde 3.3L No Start VIN: 2C3EL56T4R
I thought i had this one fixed i had a post on this last week the car came in with a skip #1 coil driver was grounded replaced computor skip was gone but car bucked and cruise light flashing replaced cam and crank sensors all was well two days later the car ge...
|2001 Dodge Durango 4.7L No Start VIN: 1B4HR28N11
Happy 4th iATN family. I have a 2001 Durango that I'm not very familiar with. It will turn over but won't start. When you turn on the key the volt meter sits at zero and the fuel gauge says empty. The customer says it has plenty of gas. He added 5 gals thinkin...
Fixes & Summaries for Chrysler
|2000 Dodge Grand Caravan SE 3.8L iod VIN: 2B4GP44G6Y
Almost all who answered were correct with location of component circuits, however, I have not been able to get the vehicle back in my shop to determine what is using current. I will post a follow up when I get the unit in. Thanks to all that contributed to h...
|2004 Dodge Ram 1500 Truck ST 5.7L Insterument cluster VIN: 1D7HU18D74
Thanks to all that responded to my problem. I pulled the ABS connector off and found it green with corrosion cleaned it and put it together and the gauges worked fine.
|2002 Jeep Grand Cherokee Limited 4.7L No Start, Cuts out VIN: 1J4GW58N72
I would like to say thanks to all of the replies the truck was sent to jeep my service maniger did not wont to put in any more time I did hear back from them and found that thay replaced both crank and cam sensors both converters and thay checked timeing and f... Trouble codes: P0320 (no crank reference), P0340 (no cam signal at pcm), P1299 (vacumm leak found / iac-fully seated), P1389 (no asd relay output voltage at pcm).