|Prev||Professional Automotive Repair Technical Discussions for June 23, 2007
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for GM
|1985 Chevrolet Camaro Z28 5.0L turn signal stalk VIN: 1G1FP87HXF
Hey guys I am replacing a turnsignal stalk on an 85 camaro and for the life of me I cant figure out how the old one removes, I did a couple of these many yrs ago but it escapes me how it is done. Any help will be appreicated. This car has a tile wheel. Thank ...
|1992 Chevrolet K3500 Cheyenne 5.7L Hesitation, Surge, Cuts out, Stall, Misfire VIN: 1GCHK34K9N
engine surges runs bad worse when hot always in open loop engine temp on scanner is 195 truck has bad exhaust leaks at manifolds. o2 flashes back and forth between rich and lean. back fires thriugh intake and exhaust.runs rich. has the new plugs fouled out alr...
|1996 Chevrolet C3500 Cheyenne 7.4L No Start VIN: 1GCHC39J3T
the engine want to start, but can not start. fuel pressure 55 psi, very good spark, check with scan but see no codes. any ideal where to look for this problems. thank in advance to those who help. thoa
Fixes & Summaries for GM
|1993 Cadillac Fleetwood 5.7L Hesitation, MIL Lamp on, CODE 41 (NO CAM SIG) VIN: 1G6CB53B6M
OK FINALLY FIGURED THIS ONE OUT,WE APPRECIATE ALL THE REPLYS VERY MUCH.WHAT IT TURNED OUT TO BE WAS THE CLIPS ON THE INTERNAL DISTRIBUTOR HARNESS WERE BAD,AND TWO WIRES ON THE CAM SENSOR WERE FLIPPED. CAUSING THE CAM SENSOR TO BE FRIED AT EVERY START UP.WE WEN... Trouble codes: 41 (no cam signal).
|1977 Chevrolet Corvette 5.7L speedometer VIN: 1Z37L7S424
I had suggestions for underneath and up top. Since this cars is so damn tight and i dont bend well i chose to remove guages and replace it from up top, not a really bad job. Thank you all for your replies.
|1995 Chevrolet S10 2.2L Pilot bushing
Clutch job completed. I installed the bushing slightly deeper than flush. Great responses and some creative measuring confirmed this. Thanks.
|1999 Pontiac Bonneville SE 3.8L Stall VIN: 1G2HX52K9X
well lets call this closed for now re-checked fuel pressure all grounds battery connections re-scaned computer checked voltages to fuel pump and coils and map and computer and test drove this thing at least 50 more miles and have never had any problems show up...
|2003 Saturn Vue 2.2L Starter Kick Back VIN: 5GZCZ23D53
Hello everyone and thanks to everyone who replied, especially Charlie V who hit it on the head. These ignition systems require Ion sensing plugs to make them perform correctly. Once we removed the aftermarket plugs and installed OE Delco plugs, all is well. ...