|Prev||Professional Automotive Repair Technical Discussions for May 6, 2007
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Asian
|1988 Acura Integra LS 1.6L No Start VIN: JH4DA185XJ
When car is hot and shut off, will stall upon restart, then not start for a few minutes. You have to cycle the key on until you hear the fuel pump engage before it will restart. It is severely worse when the weather is hot.
|1999 Honda Passport EX 3.2L windshield wiper motor VIN: 4S6CK58W1X
The wiper blades stop any place when you turn off wipers, the Honda dealer said to replace alarm box, I wonder if you could wire around it?
|2004 Honda Pilot EX 3.5L driveline VIN: 2HKYF18404
hi Honda tech`s - hope you can help me with this problem - VTM lamp comes on after vehicle is warmed up and driven at80 mph for as little as one minute, on decell at about 70mph it feels like wheels are loose, and vibrates thru steering. the VTM lamp comes on ...
|2000 Nissan Frontier XE 2.4L MIL Lamp on VIN: 1N6DD26S1Y
hello, everyone i have been having trouble with my 2000 nissan frontier xe truck with reading a code of p0302 which states that cylinder no. 2 has misfire... so i change all of the spark plugs and wires and rotor and distributor cap and the light stays off for... Trouble codes: P0302 (cylinder no. 2 misfire detected)
Fixes & Summaries for Asian
|1998 Toyota Sienna LE 3.0L hydraulic module VIN: 4T3GF13C7W
Hi, sorry it took me so long. I was waiting for the guy to come up with the money, the hydraulic unit runs 17,00 bucks from the dealer, its pricy but needed to continue testing and fix. The line to the left rear wheel is clear so it only leaves the hydrulic un...
|1999 Toyota Camry CE 2.2L Starter VIN: JT2BG22K1Y
Well first thank you to all who posted. The short version is car went home and customer hasn't called, so it fixed itself. I instructed the customer if the problem reoccurred, he should pull the dome light fuse therefore removing the power before the relay. ...