 Prev |
Professional Automotive Repair Technical Discussions for January 7, 2007 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for GM
| Help Request | Answers | |
| 1997 Chevrolet Corvette 5.7L Vent system VIN: 1GYY22P3T5 Guys i dont have much info to go on here and am just looking for some possible common failures. This corvette will not switch from vent, floor. I scaned BCM and PCM found no codes found. I checked for vacuum leaks found none so far, control head seems to funct... |
View | |
| 1999 Chevrolet S10 LS 4.3L MIL Lamp on VIN: 1GCCS19XXX Hi everybody.I have this truck chevy s10 vin x 4.3l,a/t it has code 404 & sometimes 452.I know in the past fuel tank pressure sensor shorts out & causes 5v reference to drop & cause short to other sensors.Customer took it to the dealer & told her to replace th... Trouble codes: 404 (egr feedback voltage out of range), 452 (fuel tank pressure sensor low or shorted) |
View | |
| 1997 Geo Metro LSi 1.3L Mechanical VIN: 2C1MR2296V i need advice from someone who has installed a jap engine in one of these. the place that sold it to me said i would have to reuse the original crank sensor how ever theres no place to install it(the oil pump/frt cover is different) do i neeed to transfer the ... |
View | |
| 1992 Pontiac Grand Am SE 3.3L engine VIN: 1G2NE14N9N hey pontiac guys, i have this 92 grand am se, 3.3 that the customer came in for an over heating problem. customer stated that car over heated and when over heated, coolant guage, oil pressure guage, and battery guage all rose to redline. also that heat would i... |
View |
Fixes & Summaries for GM
| Fix/Summary | Answers | |
| 1989 Pontiac Bonneville LE 3.8L master cylinder VIN: 1G2HX54C9K Thanks for all the help. Most of the suggestions were things we had tried prior to the post. After the vehicle sat overnight, we opened the bleeder at the front wheel and fluid started flowing. We immediately began to re-bleed the system and it finally respond... |
14 |
