|Prev||Professional Automotive Repair Technical Discussions for January 7, 2007
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|1994 Ford F-150 XL 5.0L Poor Idle Quality, Hesitation, MIL Lamp on VIN: 1FTEF15N7R
truck runs good until it goes closed loop. scanner shows o2 over a volt in cl break out box shows a negative reading at this time. i have always thought a neg reading meant bad 02. have tried 2 02 sensors and a reman ecm. have cleaned harness from o2 to fender...
|2002 Lincoln Navigator 5.4L No Start VIN: 5LMFU28R62
Customer says instruments went haywire off and on a few times and he did not notice any driveability problems, parked vehicle and let set for a while and it would not start towed to shop, I found no fuel press. so I checked inertia switch it was ok but no powe...
|1989 Mercury Grand Marquis GS 5.0L Hesitation, Cuts out, Stall, Misfire VIN: 2MEBM74F5K
This car at times will stummble,hesitate and run poorly. I checked fuel pressure,it has 31 psi at idle when at proper running temps and has 40 psi with vac unplugged from regulator. I can get a quart of fuel in less 20 seconds. My questions is, What pressure s...
Fixes & Summaries for Ford
|1995 Ford Thunderbird LX 4.6L No Start VIN: 1FALP62W95
Thanks guys. Customer helped solve. Talked yesterday and she mentioned that she had the alarm system 'disabled' sometime back and could this be part of the problem? Had no idea it had an alarm; no horn in the bay, no visible taps or splices and the installers ...
|1997 Mercury Cougar XR-7 3.8L No Start VIN: 1MELM6247V
Thanks to every one, finally this car is fix, after rechecked ground and power I found all ok so we decided to take the car to the dealer and let them reprogram the comp. and still the same they say was a defective computer (aftermarket computer, sorry for don...