|Prev||Professional Automotive Repair Technical Discussions for December 10, 2006
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for GM
|1987 Chevrolet S10 2.5L Oil pan leaks VIN: 1GCBS14E0H
Guys, I hate to do this, but sometimes this is needed due to the situation I am in... so I come to the right place. To make a very long story... SHORT, I changed the engine in this truck with a long block engine I bought. The engine runs fairly well after conv...
|1997 Chevrolet Camaro Z28 5.7L No Start VIN: 2G1FP22P3V
this car came in about a month ago with a leaking waterpump, replaced it and the entire optispark assmembly/ ignition wire set.About 2 weeks later the customer brought it back to us with an interm. long cold crank. We found the fuel pressure would not hold, it...
|1998 Oldsmobile Aurora 4.0L MIL Lamp on VIN: 1G3GR62C0W
Intake Manifold "spring loaded trap door"? First time I've seen this. Owners complaint is CE lite, runs fine. Codes P0171 and P0174. I can spray carb cleaner at loud "whistling" trap door at front of intake manifold and bring LTFT from + 37% down to normal, or... Trouble codes: P0171 (Lean Bank 1), P0174 (Lean Bank 2)
Fixes & Summaries for GM
|1999 Chevrolet Tahoe 5.7L Distributor timming VIN: 1GNEC13ROX
Thanks too all who responded.23 in all. Finally I replaced the distributer and fix that problem.didn't see any thing wrong with it.Maybe shaft was twisted.Secatary sent core tn before I could take it apart. then I diagnosed the tranny problem.The pan was full ...
|2003 Chevrolet Silverado 1500 4.8L door panel VIN: 1GCEKI9V13
Good morning everyone I would like to thank everyone for the quick responses.Keith [...] explained exactly what to do.I didnt know that there was a screw behind the lock slider,I took that out and had the panel off in 5 minutes.I put a new sp...