Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for October 23, 2006
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
1991 Dodge Grand Caravan LE 3.3L abs VIN: 1B4GK54RXM
This is a Bendix 10 ABS System,when the car first came in the pump would not come on,and the brakes pedel was very hard,the hydraulic unit was replaced and the pump began to work and shut-off normally,but,after letting the vehicle set for awhile,the pedal was ...
1996 Dodge Ram 1500 Truck 3.9L Misfire VIN: 1B7HC16X7V
I cant figure this one out at idle this truck seems to have a misfire condition it vibrates like a mug. Misfire counters are 0. I removed belt to rule out fan clutch vibration. Scope looks good on all cylinders. No codes hc's are a little high at idle. st fuel...
1999 Dodge Ram 2500 Van 5.2L No Start VIN: 2B4JB25Y0X
vehicle came in as a no start condition. found engine full of fuel. drained engine oil and gas from crankcase. tried to access computer, but only will allow intermittently. when accessed will kick me out after ten to fifteen seconds as no comunication. I think...
2002 Dodge Neon SE 2.0L No Start, Anti-theft engaged VIN: 1B3ES46C62
Thanks in advance for your time. To start with yes I am using a DRB. I am unable to program the new keys for this vehicle. I have the SKIM PIN, and the DRB says it is correct, but when I attempt to program the keys it says programming failed. When I run a bus ...
2003 Dodge Ram 3500 Truck 5.9L rear axle VIN: 3D7MU48C33
At slow speeds there is shudder coming from rear when slowing between 20 to 5 mph. Problem occurs with or without brake applied and quits under 5 mph or upon accelerating. Problem did not seem like warped rotors but brakes were worn very thin along with excess...
1998 Plymouth Voyager 3.0L no start VIN: 2P4F2532WR
Intermittantly van won't start. No crank. Apparently no sound (no click) , dash lights (warning lights) light up- but no crank at all. Dad was stuck in a parking lot for 1/2 hour + cranking away with no luck. He calls me, I drive there, reach in the window to ...

Fixes & Summaries for Chrysler
Fix/Summary Answers
1990 Dodge D250 5.9L Daytime Running Lights VIN: 1B7KE2686L
Thanks to all who responded to this request, especially Kyle who clued me into having the vehicle moving, and Jason who sent me a wiring diagram. It wasn't quite the same as the wiring on this truck, however it confirmed my hunch that the problem was in one of...
1998 Dodge Dakota 3.9L Cuts out, Stall VIN: 1B7FL26X6W
We finally got this fixed. The problem turned out to be a bad crank sensor. We found it with the labscope. When the tempurature was cold, we would loose part of the signal. Replacing the sensor took care of it. Thanks again for the help. Paul Trouble codes: P0320 (Ign Ref - 130 Starts Since Set).
1999 Dodge Ram 1500 Truck 5.9L Radiator VIN: 1B7HC13Z1X
First off, I want to thank all of you that responded. What I found to be the problem was a pretty strange situation. I was pretty sure that there was an electrolysis problem, but it was going to be hard to find. I first replaced the leaky radiator and th...
2002 Dodge Grand Caravan Sport 3.3L steering VIN: 2B4GP44R82
thanks to all that reminded me to do the very thing i preach- look at tsbs. we did the hose update and so far so good- not sure how a flush got this going but none the less we are out of the woods- thanks again to all- greg and crew
2002 Dodge Grand Caravan Sport 3.3L ABS light on VIN: 2B4GP44392
Thanks to all that responded. It did have 12 volts at fuse 21, but after finding a wiring diagram and finding the correct wire it did not have 12 volts at the cab. Only about .3 volts. The wires run under the battery box. The dk green/red wire to cab was rubbi...
1999 Jeep Grand Cherokee Limited 4.0L front drive area VIN: 1J4GW68S9X
found transfer case front out put bearing out, could feel it by hand but ran it in low lock on lift could see front out put jump and is making noise internaly, replaced transfer case no noise, thanks.
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next