Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for August 5, 2006
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Asian
Help Request Answers
1997 Honda Civic EX 1.6L Hesitation, Cuts out, Stall VIN: 1HGEJ8146V
This vehicle runs ok cold. As the temp climbs up the problem becomes more frequent. When you try to accelerate under load in second or third gear the engine just bogs down. The only way to keep it from stalling is to return the throttle back to idle and let th...
View
1993 Nissan 240SX 2.4L Excessive Emissions, MIL Lamp on VIN: JN3MS37A1P
Hi...I am probably going to head to the egr temp sensor on monday..need a break..I have included a pic of the egr/cannister/scv sol. this is located on back of cyl head ..dont have a concise schematic for it so part of my post is in regards to any corrections ... Trouble codes: 32 (egr problem)
View
1992 Toyota Land Cruiser 4.0L charge light VIN: U-HZJ81-00
Hi there, I have an old landcruiser which is giving me some grief. the Alternator charge light has been coming on and off this is concerning the customer. when the light comes on the voltage gauge stays at the normal reading of just over 14 volts. i have teste...
View

Fixes & Summaries for Asian
Fix/Summary Answers
2005 Acura RL 3.5L No Start VIN: JH4KB16595
I removed the ECM, removed the cover & ckd for water intrusion, it appeared that water had been there, but was dry, I dried it out with air to verify no further moisture present & re-installed it. I could read PIDS, but it still would not fire injectors or coi...
7
1996 Honda Accord EX 2.2L Misfire VIN: 1HGCD5658T
Most replied about egr passage, i pulled the cover off and all cylinders were plugged cleaned. on valve adjustment is at high side of spec's. i even pulled the exhaust manifold and watched it run with manifold off. problem is not valve adjustment. compression ... Trouble codes: 301 (cly one missfire), 302 (cly two missfire), 303 (cly three missfire).
19
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next