 Prev |
Professional Automotive Repair Technical Discussions for July 23, 2006 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 2001 Nissan Sentra GXE 1.8L Poor Idle Quality, Cuts out, Stall VIN: 3N1CB51D71 This must be my week for headaches as this nissan was towed in for no go. Upon testing found fuel pressure was low, replaced with bosch pump, now have good pressure however engine will not idle has spark and noid all the time while cranking and until it dies t... |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 1986 Honda Accord DX 2.0L MIL Lamp on I received a lot of info about the vacuum chamber with 3 lines on it in the vacuum box, which was checked twice. Also, the EGR valve was factory new with a new EGR Position Sensor but I checked the signal from the sensor to verify that it was working correctly... Trouble codes: 12 (EGR malfunction). |
15 | |
| 1985 Nissan 720 2.4L headgasket? VIN: JNBNDOBS7F Thanks all to have responded. Sounds like this model has a lot of problems. well i have been very sick and finally got back to this truck. I took the valve cover off and pressurized the coolant. I didn''t see any coolant leaking from the timing chain area. als... |
8 | |
| 1989 Nissan 240SX XE 2.4L MIL Lamp on VIN: JN1HS34P5K This car is finally fixed. The main problem is ecm not supplying the referance voltage or around two volt to the egr temperature sensor. The new ecm solved this problem, it supplies around two volts to egr temp sensor during idle and gradually drops down to ne... Trouble codes: 35 (egr temp sensor). |
4 | |
| 1999 Nissan Sentra GXE 1.6L starting VIN: 3N1AB41D5X Hi techs - this car is fixed. I got several replies and a copy of the diagram. Suggestions included loose terminals on the starter inhibit relay in the underhood relay box (I tightened the terminals in the box just to be on the safe side, as suggested, but it ... |
7 |
