 Prev |
Professional Automotive Repair Technical Discussions for May 21, 2005 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 1996 Dodge Ram 1500 5.2L 3-2-3 shift VIN: 3B7HF13Y6T Let me start by saying I am not a trans guy.I got this truck when the trans shop said that it is not the trans causing the problem. When taking off from a stop the trans will shift from first to 2nd fine, it will shift into 3rd at about 45 mph, and at 50 mph i... |
View | |
| 1994 Jeep Grand Cherokee Laredo 5.2L No Start, Cuts out, Stall, Misfire VIN: 1J4GZ58Y7R Hi Gents, Need a Jeep techs help, have a friends "heep" here a Consumers power meter reader truck that has a start stall condition when cold, after 1-1.5 hrs of run time the volt gauge reads 9.0v and the engine seems to run Ok. Shift points are are very incon... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 1999 Chrysler 300M 3.5L Surge, Stall, MIL Lamp on VIN: 2C3HE66G3X Special thanks to Morgan, Duane, and Chris for their assistance. Went in the next morning with scanner attached and scope back probed at the TPS. They both read .53 volts briefly and then they would jump up to 4.69 V on the reference orange wire. Found the Map... Trouble codes: 123 (Throttle position sensor voltage higher than expected). |
3 | |
| 1996 Dodge Neon 2.0L drive cycle problem VIN: 1P3ES47C4T MANY THANKS TO ALL OF THE TECHNICIANS THAT RESPONDED! Most were right on target. A simple ECM reflash fixed the problem. I found out that this is a very common problem. The original programming set all monitors to not ready when the ignition switch was turned ... |
17 |
