Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for May 5, 2005
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2001 Chrysler Sebring LXi 2.7L crank and fuel pump fuse no 8 / 8w-10-11 VIN: 1C3EL56U71
Need a chrysler tech specialist ,I have a weird one with no direction. Car towed in with no start no crank. Battery was low and failed load test after being charged. At that time found fuel pump and crank fuse blown no 8 / 8w-10-11. Multiple starts were ok rel...
1997 Dodge Ram 1500 Truck 5.9L Cuts out, MIL Lamp on, a/c on only VIN: 1B7HF13Z7Y
HELP! vehicle lurches,jerks etc. just like you would expect a bad tps to do,but only when a/c cycles on.All parameters are normal at tps untill a/c comes on then actual voltage at sensor is normal but voltage at mastertech reads 5v and stays there regardless o...
1999 Dodge Ram 1500 Truck 5.9L no start VIN: 3B7HF13ZXX
this truck was tow-in no start, customer said the truch was reunning good then stall while driving he said the truck start back up but had no power he then left the truck running for about 15 min the truck then stall and will not start back up. my diagnostic f...
1999 Dodge Dakota 3.9L Stall VIN: 1B7GG22X9X
C P Rail truck backing up all the time stall in rev. and 1st. all other ok did trans,new throttle body,pcm, crank cam sensors,fuel filter,full tune up.fuel pulse with gose to 10 to 14 iac starts at 10,12 gose up to 55 the timing chain was done, repair wires fr...
1990 Eagle Talon 2.0L starter VIN: 4ESCS44R2L
hello fellow techs i have a starter here that makes a loud grinding type noise when starting it also has broken the first starter.we have removed the trans tryed a different flywheel and sent the other to the trans shop to make sure it was the right one any he...
1998 Jeep Grand Cherokee 5.9 Limited 5.9L MIL Lamp on VIN: 1J4GZ88Z7W
have had four faulty leak detection pumps. called identafix to make sure I was testing it right. I was told that the diaphram should hold a vacuum, I dont see any reason why it would be designed to bleed off, It would not make any sense. the first pump wouldn'...

Fixes & Summaries for Chrysler
Fix/Summary Answers
1987 Chrysler Conquest 2.6L Excessive Emissions, Poor Idle Quality, Surge
Thanks for the replies! The owner found some injectors on eBay. They were not factory injectors, but they did fix the car!! Thanks again!
2001 Chrysler LHS 3.5L MIL Lamp on VIN: 2C3AC56G41
Hello, I ended up sending this one back to the dealer, I asked the customer to let me know what fixes the car and I will post it when they let me know. Trouble codes: 456 (Small Evap Leak).
2002 Chrysler PT Cruiser 2.4L engine VIN: 3C4FY48B82
We told the customer that she most likley had a bad converter and she wanted to take it back to the dealer for warranty. I spoke with her today and the dealer confirmed the converter was bad. Thanks for the replies.
1995 Dodge Intrepid 3.5L Stall, MIL Lamp on VIN: 1B3HD46F75
We received 9 replies, most said timing belt jumped, a few mentioned egr valve problems. We removed the egr valve to find no gasket, causing vacuum leak. Put new gasket in & problem was solved. Thanks for your help. Trouble codes: 51 (lean right bank).
1998 Dodge Ram 1500 Truck 5.2L Poor Idle Quality, Surge, Misfire, Poor Fuel Economy, MIL Lamp on VIN: 3B7HF12Y4W
Great call on the o2s, with further investigation and tracing wires the culprit was the upstream o2s, wire was wore through shorted to voltage also on the same circuit as the injectors. replaced o2s vehicle runs and performs great. great thanks to all Trouble codes: P0300, P0301, P0307, P0302, P0131, P0132.
2002 Dodge Ram 1500 Truck 4.7L compressor VIN: 3D7HU18N72
this vehicle had a bad evap temp sensor i replace the sensor and condensor fan motor the system now works great
1992 Eagle Talon 2.0L Surge, Cuts out VIN: 4E3CS44R6N
First, I want to thank everyone who responded. We checked grounds and they were all ok. We then moved on to the ecm. After removing the ecm we found a burn spot on the board inside. We replaced ecm and drove vehicle. We had no surges and vehicle never cut-... Trouble codes: 44.
1997 Jeep Grand Cherokee Laredo 4.0L Battery Draw VIN: 1J4GZ58S1V
well, checked all door ajar switches, VTSS tunbler switches, rear coutosey disable/overide switch, wires to rear hatch in bend bellows, unhooked all circuits in dash, HVAC head, Driver info center head in lower panel, headlamp switch, radio, rear wiper control...
2001 Jeep Grand Cherokee Laredo 4.0L Cuts out, MIL Lamp on VIN: 1J4GW48S21
i finally found that the camm sensor fixed this problem Trouble codes: 301 (cylinder 1 misfire).
1998 Plymouth Neon High Line 2.0L unknown VIN: 3B3ES47Y8W
thanks for the replies. it ended up being the front motor mount not properly aligned.had replies of cracked flexplate and faulty new mounts and poss ignition miss.
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next