|Prev||Professional Automotive Repair Technical Discussions for April 10, 2005
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1993 Chrysler Town & Country (Van) 3.3L cat con gets red hot VIN: 1C4GH54R6P
The car runs fine. There is no check engine light. I hooked up the scanner and found no codes. All PDI'S were within the parameters except for the O2 sensor was showing that it is running rich. I also decided to scope the ignition system and I found a low volt...
|1996 Dodge Grand Caravan SE 3.3L Misfire, MIL Lamp on VIN: 1B4GP44R5T
This one came in with a code #302- misfire on cyl.2. Replaced plugs, wires and still misses after put hard underload. On first start, can feel miss but no chk. light, but only after underload it appears. Thinking pcm is at fault, but haven't found info for thi... Trouble codes: 302 (2 cyl. misfire)
|1998 Dodge Ram 3500 Truck 5.9L computer won't scan VIN: 3B6MC36Z5W
This truck was brought in at the first of the year on the back of a hook. They had attempted to install their own transmission under a shade tree. Upon inspecting this truck for a no start condition I found that they had crushed the Bank 1 O2 sensor wiring har...
|1996 Plymouth Grand Voyager SE 3.3L No Start VIN: 1P4GP44R4T
hey guy's i need help with this basket case! it died while driving down the road & coasted to stop. it came in on the hook from another shop & had several things thrown @ it--coil pack--cam & crank sensors & pcm.the codes stored were for all the above sensors....
Fixes & Summaries for Chrysler
|1997 Chrysler Neon 2.0L Cuts out VIN: 1C3ESA7C9T
Hi all, the majority of replies advised that the wiring to the sensor overheats and welds itself together. This was the case with this vehicle but the sensor also turned out to be faulty. I couldn't pick up a fault with the crank sensor on an oscilloscope but ... Trouble codes: P0351 (ignition coil No 1 primary cct).