Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for December 30, 2004
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
1995 Chrysler Cirrus LX 2.5L No Start, Stall VIN: 1C3EJ56H4S
this cirrus starts and immediately dies. disconnect map sensor -no change. it cannot be kept running w/foot on accelerator.all scan data looks normal. no codes are stored. archives has a million cases of coil(distributor) failures, but the symptoms(and the fac...
View
1996 Chrysler Town & Country (Van) 3.8L MIL Lamp on VIN: 1C4GP54L3T
Looking for some direction on this van. Van came in with complaint of check engine light on. Code in system at that time was for cyl #1 missfire. It was in real need of a tune up. At this time I tuned it up & cleaned the injectors with motorvac and cleared cod... Trouble codes: P0300, P0301
View
2000 Chrysler Sebring LXi 2.5L starter VIN: 4C3AU52N8Y
hello chrysler techs I have a sebring coupe that when the temp gets below 10 degrees F. the starter is inop. The customer had it at the dealer last winter and they installed a new starter to try to fix the no start. That did not fix the problem. I have heard t...
View
2002 Chrysler 300M 3.5L No Start VIN: 2C3AE66G62
Hi, Chrysler techs, This car blows the S fuse which feeds the IGN coils. Coils all ohm @1 , Same as a known good car . If I disconnect PCM the short goes away. I'm thinking bad PCM, am I missing somthing?
View
1999 Jeep Grand Cherokee Limited 4.7L engine VIN: 1J4GW68N5X
I am looking at this Jeep to buy to use as shop vehicle and to tow behind my motor home but have a noise in engine on start up. After about 15 minutes noise is gone. When first started there is a noise coming from the R/F of engine by the front of valve cover ...
View
2000 Jeep Grand Cherokee Limited 4.7L key will not come out VIN: 1J4GW4853Y
Boss ordered new lock cylinder and key from dealer,leaves town,then i ordered one because key wont come out.Pull lock cylinder out of vehicle everything works fine.Has anyone seen interlock problems w/these jeeps,please help!!!
View
2001 Jeep Cherokee Sport 4.0L No Start, Misfire, MIL Lamp on VIN: 1JFF48591L
OK,Attention jeep techs, this vehicle arrived at our shop after the customer called requesting price for injector replace (only #3 injector), he had vehicle at another shop and they found code po303 but didnt verify trouble source, reset the light and he took ... Trouble codes: P0300, P0301, P0302, P0303
View

Fixes & Summaries for Chrysler
Fix/Summary Answers
1998 Dodge Ram 2500 Truck 8.0L abs VIN: 1B7KF23W3W
Thank you to the 4 who replied to this great mystery. After many hours of head scratching and poking around I finally came up with some answers. I'll just detail the tests that pointed me in the right direction. I connected an ohmmeter between ground and the...
4
2001 Dodge Ram 1500 Truck 3.9L Misfire, MIL Lamp on VIN: 1B7HC16X01
we decarboned this motor, and it is got rid of the cold mis fire, it is been gone for a couple days. thank you for all the help. Trouble codes: 305 (cyl 5 misfire).
8
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next