Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for November 25, 2004
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Asian
Help Request Answers
1993 Honda Accord LX 2.2L MIL Lamp on VIN: 1HGCB7652P
i cannot find the diagnostic connector on this accord.mitchell said it should be under the glove box but the only one i found there is the trans diag. connector,the blue one.i think it should be green for the engine.if anyone can help!
1985 Toyota Cressida Luxury 2.8L No Start VIN: JT2MX73E6F
Car starts hard cold. Loosing fuel pres. over night. Cold start inj is working. What is not happening is a 3-sec run of the pump when key is in the on pos. Is this the way it is supposed to be? Should fuel pressure hold at 40 over night? Watching fuel gauge ...
1991 Toyota Tercel DLX 1.5L No Start, Hesitation, Surge, Cuts out, Stall
Hello, . I've got a 1991 Tercel with a 1.5L in the shop. It stalls when accelerating from idle and is hard to start once stalled. When it does run it runs well, 20 in hg. Fuel pressure at idle is 34 psi with 20 in hg at the pressure regulator, with 0 in hg at ...

Fixes & Summaries for Asian
Fix/Summary Answers
1999 Honda Civic EX 1.6L Electronic VIN: JHMEJ6680X
everyone is right on the ball with this one; removed the support bracket under the intake manifold & voila, bare wires shorting to the bracket...thanks IATN, saved a lot of time on this one...HC
2003 Honda Odyssey EX 3.5L sliding door VIN: WERTKL7634
I was waiting to post a fix with the methods of reteiving cdes from the honda but no on replied with a list. there is a way of getting codes with a flshing light. also if the door gets confuse and stops the power movment removing the fuse 13 on the passenger s...
1996 Isuzu BIGHORN 3.1L idling VIN: UBS69GW-72
Thanks to both Alex and Mike for their replies, the reason I have not closed this reply yet is the problem does not occur when it comes into my workshop. The TPS and ICS were all checked and testing fine, I did adjust the TPS by 1 volt as the setting for this ...
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next