Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for July 30, 2004
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
1996 Chrysler Sebring JX 2.4L duct work VIN: 3C3EL45X6T
hey guys, when i put the controls to just the vent on this gem it comes out the vent but also a fair amount comes out the defrost duct too. I recently put a actuator motor for the vent controls in because when you put it to vent nothing happened at all. I'm n...
View
1997 Chrysler Town & Country (Van) LX 3.8L Stall, Misfire, MIL Lamp on VIN: 1C4GP54L1V
OK... Thought this one would be easy, hell 3.8s are pattern fail children arent they? Towed in, no RPM signal. Crank sensor open, zero signal. Install new crank sensor, fires up and runs great. Customer pickes up, drives away, gets towed back in an hour later.... Trouble codes: P1391, P0352 (Coil Primary Driver 2 Problem), P0300 (Random Cylinder Misfire)
View
1999 Dodge Ram 2500 Truck 5.9L Poor Idle Quality, MIL Lamp on VIN: 3B7KC2365X
Scanned for codes had a po 181 . Truck runs good going down the road but has a rough idle like it isn't running on all cylinders. If we clear the code it comes back right away. It looks like the injection pump is bad but I would like another opinion. Also will... Trouble codes: P0181
View
1999 Dodge Ram 1500 Van 5.9L chassis VIN: 1B7HF16Z3X
i have been searching for a clunk on a hard accel only. the motor mounts are new factory units. there is no play whatsoever in the front end. the driveshaft has no play in the u-joints. i have tightened all bolts and nuts to anything that connects to the chass...
View

Fixes & Summaries for Chrysler
Fix/Summary Answers
1994 Chrysler Concorde 3.5L Compressor VIN: 2C3EL56F0R
Thanks to all for the help. Replacing the transducer fixed the problem. Hope I can return help to you guys soon.
15
1996 Chrysler Town & Country (Van) LXi 3.8L No Start, MIL Lamp on VIN: 1C4GP64L7T
First I would like to thank you to all who responded. I suspect it was the flywheel. But, before I decided to remove the transmission to inspect closely. I just want to double check all the reading again. To make sure I don't waste 5hrs for nothing. While I wa... Trouble codes: 11 (No cam or crank signal).
5
1988 Dodge Dakota 3.9L Hesitation, Surge, Stall
First I would like to thank everyone for their thoughts on this on, and info on asd function. I had to back up to basics and start with what I new was a problem. Fuel pressure would not hold with koeo also when reving pressure might fall slightly but no raise....
8
1992 Dodge B250 5.2L Excessive Emissions, Misfire, Poor Fuel Economy VIN: 2B6HB21YXN
Thanks for all the suggestions I recieved. I replaced the O2 sensor again and problem appeared to correct. The injector on time dropped from 9-14ms to 4.5 steady. I recieved input about possible fuel regulator, sych timing, egr stuck open and purge solinoid, b... Trouble codes: 21 (o2 not switching).
8
2001 Dodge Ram 2500 Truck 5.9L Body/interior VIN: 1B7KC23Z91
Still not fixed, - have not had the time to tear this thing apart (which is what will probably have to be done in order to fix). Suggestions included, - 3rd brake light sealing problems, windshield (replaced), door panel trim sealing, roofrail seal, etc.
5
1992 Eagle Talon 2.0L Excessive Emissions VIN: 4E3BS44R7N
This one is fixed, FINALLY. And it turns out that Walker muffler strikes again! It turns out the original diagnosis was correct all along--the converter. The problem lies with the manufacturer, Walker exhaust. These guys really had me chasing my tail for nothi...
7
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next