|Prev||Professional Automotive Repair Technical Discussions for June 20, 2004
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
Fixes & Summaries for Chrysler
|2004 Chrysler Caravan 3.3L engine
Well, I finally got around to fixing this Dodge product. Cyl #5 wrist pin was freezing up in the piston as the crank turned causing the knock. The piston was damaged and replaced with the rod assy. Thru some new rings on it, honed the cylinder. Looks good to g...
|1989 Dodge Dynasty LE 3.0L fuel come from exhau VIN: 1B3BC5639K
I wont to think all of you for your help ,it was varry good. Russ you nailed it , the computer was comanding to much fuel i replaced it, that took care of my problem,.thinks to all of you.
|1997 Dodge Intrepid 3.5L No Start, Stall VIN: 2B3HD46FXV
Thanks to all that replied, Everybody that thought it was a timing problem was partially correct, the fix was to replace the left hand cam gear with the proper one, the reman engine came with the wrong gear, the one it came with had 6 events on the cam sensor ...
|1998 Dodge Stratus 2.4L cv joint VIN: 1B3EJ46X0W
Most of the replies Iv'e received recommended new factory wheel bearings. Since the customer just had new aftermarket wheel bearings installed. That would be the first place i will check. Also worn sway bar bushings were mentioned. The customer is going to bri...
|1992 Eagle Talon TSi 2.0L Excessive Emissions, Poor Idle Quality, Surge VIN: 4E3CT64U4N
This vehicle is fixed. First the egr valve was dirty. cleaned it and it helped but not totally. then i also found i had both cam's off in timing. I had the intake cam 1 notch counterclockwise and exhaust cam 1 notch clockwise. This cured the problem and suspec...