 Prev |
Professional Automotive Repair Technical Discussions for September 23, 2026 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for All Makes and Models
| Help Request | Answers | |
| 2005 Honda CR-V EX 2.4L 2-3 Shift VIN: JHLRD78825 This is my own CRV and trying to figure out the shifting problems. I changed the B-C solenoids because one connector fell off while removing it to clean the screens behind it. I removed the A solenoid and cleaned the screens under it. When I drive it, firs... |
View | |
| 2009 Hyundai Sonata GLS 2.4L Steering rack VIN: 5NPET46C59 Tried clearing code but came back don't have Alldata or manual |
View | |
| 2016 Kia Sedona LX 3.3L Trans or engine VIN: KNDMB5C11G Hello everyone. This is a strange request for advice. I'm trying to pin point an oil leak on this 16 Sedona before I continue with the repairs. Oil is leaking from between the transmission bell housing and the engine. I removed the small inspection cove... |
View | |
| 2008 Mazda 5 Sport 2.3L transmission VIN: JM1CR29378 Installed used transmission, car previously had gear ratio codes and p0720 was present. replaced trans, ration codes resolved, approx 50 miles later p0720 reappeared. sensor was replaced, harness and connectors gone thru, tcm replaced, code returned at abo... |
View |
Fixes & Summaries for All Makes and Models
| Fix/Summary | Answers | |
| 2010 Chrysler Sebring Touring 2.7L starter VIN: 1C3BC5ED7A car is fixed. as stated, the range switch changed the problem, but after checking and re-checking i put an ecm in it. i think there was more than one problem. hope this helps some one else. thanks to iatn and all the members. |
3 | |
| 2007 Honda Element EX 2.4L MIL Lamp on VIN: 5J6YH28767 so the shop that brought it to us said they already put a new pcm in and it didn't fix it, the problem is when they did this they had put a bad oil pressure switch in so it still did not work, I showed the switch changing state when the oil pressure was turned... Trouble codes: P2646 (Rocker Arm Oil Pressure Switch Circuit Low Voltage). |
5 |
