 Prev |
Professional Automotive Repair Technical Discussions for May 29, 2026 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for All Makes and Models
| Help Request | Answers | |
| 2020 Ford Fusion Titanium 2.0L Rear Differential VIN: 3FA6P0D97L Has anyone else seen an issue with fluid leaking out of the rear diff. vent tube and blowing it all over the left rear inner fender, shock, control arms, etc? I have had three vehicles with this issue and when I check the fluid level they are nearly empty.... |
View | |
| 2015 Honda Odyssey Touring 3.5L Alternator VIN: 5FNRL5H93F Customer complaint is battery light comes on. Verified the vehicle does not maintain proper voltage with loads on. According to mitchell under 13.2 turns on the battery light. Have not personally seen battery light come on yet. We are getting down into the... |
View | |
| 2012 Jeep Wrangler Unlimited Sahara 3.6L Misfire VIN: 1C4HJWEG3C After all repairs and clearing all adaptive. Relearn crank/cam and idle. On the third key cycle / long drive, cylinder one misfire starts to count up to 200 plus. Sometimes cylinder 3 and 5 will have some misfire counts too. The engine shows very slight mi... Trouble codes: P0301 (Misfire cylinder one), P0300 (Random misfire) |
View | |
| 2020 Mazda CX-9 Signature 2.5L Poor Idle Quality, Misfire VIN: JM3TCBEY1L came from another shop mass air flow was not reading egr was sticking. replaced mass air removed egr and cleaned. just unplugged for time being pricey little fellow. Now runs good off idle ,soon as sets and idles for a couple of minutes starts back missing... Trouble codes: P0300 |
View | |
| 2018 Nissan Kicks S 1.6L Poor Idle Quality VIN: 3N1CP5CU6J There is only 4.7 volts on the power wire (red) at Mass Air Flow Sensor plugged in. MAF ground wire confirmed good. 12 Volts should be supplied be the ECM. There is only 4.7 Volts coming out of ECM at connector. Substituted a used computer with same result... Trouble codes: P0102 (Intake Air Temp Circuit), P0300 (Random misfire) |
View |
Fixes & Summaries for All Makes and Models
| Fix/Summary | Answers |
