 Prev |
Professional Automotive Repair Technical Discussions for August 18, 2023 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for All Makes and Models
| Help Request | Answers | |
| 2012 Ford F-250 Super Duty King Ranch 6.7L warning on dash VIN: 1FT7W2BT9C Vehicle brought here (owner's truck) with the complaint of a low fuel pressure warning on dash. I test drove the vehicle with no performance concerns. Using Snap-On Solus scanned these DTC's all past. The only thing flagging my radar is the fuel pump is no... Trouble codes: P2539 (Low pressure fuel system sensor circuit), P0087 (Fuel/rail system pressure - too low), P008A |
View | |
| 2017 Hyundai Tucson 2.0L Unsure This one has me stumped. It has a very noticeable noise in the front end. Sounds like a grinding sound at first I thought it was brakes but they are new and checked out(no rubbing, etc) Got the wheels off the ground and you can clearly hear it from the dri... |
View | |
| 2008 Volvo XC70 3.2 3.2L No Start, No Start VIN: YV4BZ98248 Vehicle was towed in, stalled while driving. Starts for about 2 seconds, then stalls, and crank no start after that. Using only fuel rail pressure sensor and not physical pressure gauge, fuel pressure was low. Accessed tank unit and checked power and groun... Trouble codes: P0193 |
View |
Fixes & Summaries for All Makes and Models
| Fix/Summary | Answers | |
| 2011 Chrysler 300 Limited 3.6L Abs Hcu VIN: 2C3CA5CG3B Thanks for the replies, The repair options are limited, pretty much used part. The car also needed the brakes replaced front & rear. I gave them the options & risks. Customer picked the up car and going to decide to trade it or fix it??? |
3 | |
| 1999 Ford Explorer Eddie Bauer 5.0L ac pressure VIN: 1FMDU32P0X so the new radiator that was replaced by another shop was 1 inch thicker. this brought it closer to the fan which could not draw enough air, even though it would suck a rag against the condenser without a problem. could not get the correct shroud so i shimmed ... |
20 |
