 Prev |
Professional Automotive Repair Technical Discussions for August 22, 2022 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 2004 Honda CR-V EX 2.4L brake pedal VIN: SHSRD78834 Car came in with pedal slowly sinking to the floor, I checked fluid and inspected all brakes, I didn't find any obvious problems so I suspected a bad master cylinder. Installed new master cylinder, bleed all brakes and still have the same problem. I instal... |
View | |
| 2008 Toyota Tundra SR5 5.7L Compressor VIN: 5TBBV54108 2008 Toyota Tundra Vehicle came in with A/C inoperative. Evacuated A/C system,Vacuumed and recharged to spec. Noticed A/C compressor runs for 3 seconds and shuts off and A/C switch is blinking. No diagnostics codes stored. Found no ground control signal... |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 2017 Mitsubishi Mirage ES 1.2L airbag light VIN: ML32A3HJ4H Once back probing I found that at one angle the codes would clear and at another they would come back. Took a little bit but found out that 2 pins in the airbag module were slightly pushed in. So we pulled them out gently and made sure the connector went on sm... |
5 | |
| 2006 Toyota Highlander 2.4L Timing/starting VIN: JTEHD21A46 Thank you everyone for your tips and advice. For starters, I checked my vacuum gauge with my mightyvac hand pump and sure enough it's way off, so throwing the cranking vacuum data out the window. The fault was the crankshaft signal plate/tone ring, I had insta... |
12 |
