 Prev |
Professional Automotive Repair Technical Discussions for November 30, 2021 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 2013 Nissan Sentra S 1.8L O2 Monitor VIN: 3N1AB7AP7D When the vehicle arrived it had O2 and EVAP monitors not set. We also found a pending P0340 for Cam Sensor circuit. ECU signal tested ok, we replaced the cam sensor, performed a capacative discharge and drove the drive cycle. All monitors run alarmingly fa... |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 2011 Hyundai Santa Fe Limited 2.4L Stall VIN: 5XYZK3ABXB As most of you suggested we replaced the Crankshaft Position sensor. I'm not sure if this fixed but I have a good feeling about it because of how common they are to go bad. FYI The car has not stalled for nearly a month prior to installing part. Thanks for the... Trouble codes: C1611 (Can-time out ecm), B1102 (Battery voltage air bag), C1121 (Tpms fault). |
3 | |
| 2017 Hyundai Elantra SE 2.0L p0017 VIN: 5NPD74LF5H Just for the record this was a wholesaler's vehicle and he bought it with the warranty cancelled. Probably directly from Hyundai. It was the pin on the timing gear. The pin walked out of the timing gear and worked its way almost flush into the camshaft. The ge... |
6 | |
| 2009 Mazda 5 Touring 2.3L air bag light VIN: JM1CR29369 Thanks to all who replied , the clock spring was bad , i got a used one off Ebay $58.00 (this was something i bought to sell on) so after it was installed the light went out & stayed out no calibration needed thanks to all again |
6 |
