 Prev |
Professional Automotive Repair Technical Discussions for September 7, 2021 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 2013 Infiniti G37 Journey 3.7L warning message VIN: JN1CV6AP3D hi techs, i got this infiniti G37s with a warning message on cluster says SHIFT TO P and also beeping sound when the key is turned off, i have no problem shifting or starting the vehicle in either P or N position, not shifting issues or codes on any module... |
View | |
| 2006 Lexus RX400h 3.3L MIL Lamp on VIN: JTJHW31U16 Hey guy i have this 2006 lexus 400h with a code p0aa6 hybrid battery voltage system isolation fault i check tha battery no water found no other codes any help or replace the battery thank you guys |
View | |
| 1998 Nissan Altima GLE 2.4L No Start VIN: 1N4DL01D1W vehicle towed in no start. spun over very slow and plugs were fouled. replaced battery and plugs. vehicle still will not start. checked fuel pressure 45 psi, took fuel sample has good gas, checked for spark is normal, unpluged injector and tested inj drive... |
View | |
| 1994 Toyota Previa LE 2.4L Poor Idle Quality, Hesitation, Stall VIN: JT3AC22S3R HI ALL,SO IVE BEEN WORKING ON THIS CAR FOR YEARS,HAS ALWAYS RUN WELL.recently has been sputtering intermittently,with no power,almost will stall.i drove it home one night,ran ok.did it a little bit,but at shop later stalled and wouldnt restart.tried later ... |
View | |
| 2003 Toyota RAV4 2.0L Timing Chain VIN: JTEHH20V73 I have this 2003 Rav4 that broke the timing chain and laid it in the bottom of the timing cover. My biggest question as this is a friends car, will there be damage to valves? This was a good running engine according to him before this happened. And if a ch... |
View | |
| 2013 Toyota Highlander Limited 3.5L Electronic Customer had vehicle at another shop for A/C inop. They replaced the compressor and could not get it to come on. Not sure why they replaced it. Flow sensor is at 3.71 volts, Lock sensor checks at 259 ohms. I am getting rpm from the sensor when I force the ... |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers |
