 Prev |
Professional Automotive Repair Technical Discussions for April 17, 2021 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for All Makes and Models
| Help Request | Answers | |
| 2007 BMW 328i 3.0L No Start VIN: WBAVC53577 No engine code. Rpm reading show 174 during crank. Engine kept running if i squirt carb. Cleaner into air intake. No power at fuel pump. Anyone has this problem before ??? Trouble codes: A0B0, A0B4, 6292 (Fuel module control voltage low), 6295 (Fuel module no control current), 629F |
View | |
| 2007 Honda Accord EX 2.4L stalling hello to all that can help honda accord came in on flat bed customer said car stalled out in drive way test drove car and found code p0171 bank 1 system to lean check all vacuum line with smoke machine and watched short and long term fuel trims reading nor... |
View | |
| 1993 Lexus LS400 4.0L Surge, Cuts out, MIL Lamp on, 41 tps VIN: JT8UF11E6P I have a 1993 Lexus LS400 here that came in for an engine lamp on under acceleration. Engine going into fuel cut mode when throttle is depress off of an idle, near 30% or greater. Found the IDL1 circuit at TPS sensor 0V at idle and scoped signal circuit to... Trouble codes: 41 (Throttle Position Sensor or Circuit) |
View |
Fixes & Summaries for All Makes and Models
| Fix/Summary | Answers | |
| 2004 Dodge Ram 1500 ST 5.7L Limp in VIN: 1D7HU18D54 Thank you all for your help. Transmission pressure sensor fixed this truck. In hindsight the problem with my diagnostic was not having all the information we?re not looking at all the information while scanning snap on scanner, I took a step [...] and started l... |
10 | |
| 2015 Jeep Cherokee Latitude 3.2L Rear Cylinder Head VIN: 1C4PJMCS3F Thanks for the help. All three replies gave same scenario. Pulled rear valve cover to inspect. We had an obvious rocker failure. Roller was seized and had a flat spot worn on it. It was also loose with no cam lobe load on it. We check all other rockers visuall... |
3 |
