 Prev |
Professional Automotive Repair Technical Discussions for September 25, 2020 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for All Makes and Models
| Help Request | Answers | |
| 2006 Cadillac SRX 3.6L P1834 TCC volt high VIN: 1GYEE63706 I am lost on this one, This vehicle sets code P1834 TCC-SS control circuit high voltage and defaults to 5th gear. I have applied battery voltage to the solenoid supply wire at the TCM and did amperage draw test on all of the solenoids at the TCM and the we... |
View | |
| 2010 Chevrolet HHR LS Panel 2.2L tcm VIN: 3GNBAADB0A I have this hhr with the tcm not communicating. Another shop replaced engine and said the tcm issue showed up a few weeks later. They put a used tcm in and brought it to me to program. I informed them that I prefer a new one and they ok it and I get new gm... |
View | |
| 2019 Ford f250 6.2L tpm module I would like to reduce the tpm threshold down 15 psi, but i do not want the tpm warning light on. I have IDS, but can not find where in the system to reprogram the threshold. Any help would be appreciated. |
View | |
| 2014 Jeep Wrangler Unlimited Sahara 3.6L MIL Lamp on VIN: 1C4BJWEG5E Replaced lifters and rockers and exhaust cam on bank2 now when i start it it throws a p0394 code checked timing, rung out all wires, changed sensors around. Scope patterns all look good. I am at the end. Even put old camshaft back in, same code. Thanks Trouble codes: P0394 (P0394-camshaft position sensor intermittent - bank 2 sensor 2) |
View | |
| 2012 Volkswagen Eos Komfort 2.0L Mechanical VIN: WVWBW7AHXC Hello everyone This EOS was towed in with a very noisy engine, customer stated that while driving the engine started sounding loud and check engine light came on. The noise sounds like a very loud lifter noise coming from the center of engine around #2 ... |
View |
Fixes & Summaries for All Makes and Models
| Fix/Summary | Answers | |
| 2014 Hyundai Accent GS 1.6L No Start, MIL Lamp on VIN: KMHCT5AE3E I forgot to mention that in the beginning of diagnosis I did check for tsbs and pattern failures and came up short. Critical step that all of us should get into a habit of doing, even for simple stuff. Yes, the crankshaft position (ckp) sensor fixed it. V... Trouble codes: P0335 (crankshaft position sensor malfunction). |
2 | |
| 2008 Jeep Grand Cherokee Laredo 3.7L MIL Lamp on VIN: 1J8GR48K38 Appreciate everyone for chiming in, I ordered the original cam position sensor from worldpac and upon reccomendation I sent that one back and replaced with sensor from the dealer; it made no difference. I rechecked the signal, power, and ground wires all looke... Trouble codes: P0440 (Camshaft Position Sensor Fault). |
16 | |
| 2010 Jeep Commander Sport 3.7L Noise In Dash VIN: 1J4RG4GK6A Thank you for all the replies. For those that wondered, the vehicle did not have to be in motion. I am closing for now as the customer has not wanted to pursue the problem, maybe if it gets worse. |
7 | |
| 2005 Mercedes-Benz S500 5.0L brakes VIN: WDBNG75JX5 This one is fixed! A huge thanks to Remigio [...]-you are the man. . I have been a tech for 22 years and I have been working on Mercedes for 18 of those years and I have never experienced this before. I know at least one of you thought that this was impossi... |
39 | |
| 2016 Mercedes-Benz Sprinter 2500 2.1L No Start So we decided to remove the HPFP to inspect further. The data does not lie. Upon removing the HPFP we had found the cause of the no start and no high side fuel pressure. The nut that holds the driving flange onto the HPFP had come lose and spun off. Therefore ... |
3 | |
| 2013 Ram 5500 Tradesman 6.7L high rail pressure VIN: 3C7WRMAL4D replaced fca/ fuel regulator. fuel rail sensor is now reading normal. Trouble codes: P0088. |
5 | |
| 2006 Toyota Corolla S 1.8L Rotors VIN: 1NXBR32E16 Time will tell with this one-replaced pads and rotors again this time with top shelve bosch rotors and akebono pads-time will tell-I will update in the future if problem returns |
13 |
