 Prev |
Professional Automotive Repair Technical Discussions for January 24, 2020 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 1997 Ford F-150 4.6L heater VIN: 1FDTX176XV Good evening all This truck came in for no heat,replaced thermostat,came back for no heat and overheating,replaced thermostat again same problem,replaced customer took to another place had system flushed still same problem,back to me replaced radiator and ... |
View | |
| 2003 Ford Ranger Edge 4.0L Excessive Emissions, Poor Idle Quality, Hesitation, Surge, Cuts out, Stall, Poor Fuel Economy, MIL Lamp on VIN: 1FTZR45E73 Has reoccurring code p0102 MAF low. powers and grounds good. IAT reads correctly but have 0.0 volt on MAF and 0.0 flow. wires to pcm have good continuity. Pinpoint test leads to bad pcm. Anyone been here with anything weird on one of these before I call it... Trouble codes: P0102 (MAF low) |
View | |
| 2014 Ford Escape Titanium 1.6L speedometer VIN: 1FMCU0JX2E Hey ford/networking guys, I hope you can help me figure out this puzzling issue im having. This vehicle came in on the hook with a shot transmission. Another tech, a good tech, replaced this transmission with a good used unit from LKQ with 40K miles. Once ... |
View | |
| 2003 Mercury Grand Marquis LS 4.6L Battery Thanks for your time to read this message, after replaced the light module and disconnect the key pad on driver door I still have a problem with bat draw. I noticed that after 5 to 10 minutes locked car the dome light turn on really dim and stays on killin... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 2008 Lincoln MKZ 3.5L Cooling Systems VIN: 3LNHM26T38 Thanks guys. All of you were right. We took it out the bottom. Pulled the cradle down and put it to the side. We don't have one of those nice engine tables but a moving dolly and a sheet of plywood works real well. Appreciate your time and input. Ron |
6 |
