 Prev |
Professional Automotive Repair Technical Discussions for January 14, 2020 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2008 Chrysler PT Cruiser 2.4L Block heater This engine use a non-intrusive (not submersed in coolant) block heater. We have checked all resources available to locate where the heater is to be installed. Instructions state "Locate cartridge hole on engine block" We have looked and can not find hole ... |
View | |
| 2007 Jeep Compass Sport 2.4L Poor Idle Quality, Misfire, MIL Lamp on VIN: 1J8FT47W57 Computer codes stored were: p0315 cranks sensor learn, p0522 oil sensor, p0335 crank sensor position, p0642 low reference voltage, p2122 accelerator pedal sensor. Also had intake cam solenoid code, but missed writing the number down. Engine was running ... |
View | |
| 2013 Ram 1500 SLT 5.7L MIL on VIN: 1C6RR7GT9D We installed a camshaft in this truck last week and right after starting it up we got the MIL on with a P0876. After clearing it, I can drive it and transmission appears to shift OK, but sets a pending P0876 (pressure switch rationality) shortly thereafter... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2014 Ram 3500 Tradesman 6.7L all control modules VIN: 3C63RPGL8E Its finally fixed after 8 hours of testing. The KIN/Ignition keyed switch was not sending signal that it was turned on. Thus the Radio Frequency Hub (RFH) was not allowing the modules to wake up and communicate. Installed a new KIN, did not have to relearn key... |
6 |
