 Prev |
Professional Automotive Repair Technical Discussions for August 5, 2019 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 1999 Ford F-150 Lariat 5.4L Excessive Emissions VIN: 1FTRX08L8X Vehicle came in for emissions failure, failed CO. Dyno pattern looked like a classic converter failure so he went and had all 4 welded in, I don't know the quality of what he put on? Reading are great at idle a free revving the engine, but if you power bra... |
View | |
| 2013 Ford F-350 Super Duty Lariat 6.7L Def VIN: 1FD8X3HT4D Vehicle came in just for a check engine light. Had codes for Nox sensor and Def heater. 3 days later check engine light comes back on and truck goes into limp mode. I scanned it and found p207f (reductant quality). So I assumed I must have got debris in th... |
View | |
| 2014 Ford Focus SE 2.0L Clutch A VIN: 1FADP3F21E Vehicle came in to shop with P0902 Clutch A Actuator Circuit Low, and a P0219 Engine Over speed. Clutch assembly was replaced and a new Clutch A motor was installed. Transmission adaptive relearn was attempted, but P0902 returned. Pin checks/voltage checks... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 2005 Ford F-350 Super Duty King Ranch 6.0L Base Oil Pressure VIN: 1FTWW31P55 Not really a confirmed fix. But it is gone and running great So I did air leak the high pressure system and found no leaks. Even removed valve covers and it was tightly sealed. Removed low oil pump and rings and were in good condition and regulator checked ou... |
16 | |
| 2008 Ford F-350 Super Duty XL 6.4L Will not start VIN: 1FDWF35R88 Replaced engine harness. The PCM connector was very touchy and would make good connection until you started cranking the engine. Every time that I would back probe the PCM wires it would make good connection. Replaced engine harness and truck runs again. |
9 |
