 Prev |
Professional Automotive Repair Technical Discussions for January 25, 2019 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2001 Dodge Ram 3500 5.9L Runs after key off VIN: 2B5WB35Z41 This vehicle had no problems until installed a electronic battery isolater. I knew how to install but i didnt. I must of surged the alt because i isolated battery from alt. All dome lights burned out. Instrument cluster cooked and bad air bag module. When ... |
View | |
| 2005 Dodge Dakota ST 3.7L MIL Lamp on VIN: 1D7HE28K95 There is no communication on can C. The only modules on c are PCM, ABS, and front control module. Checking at DLC #6 and ground and 14 and ground both have 2.5 volts. Checking with a lab scope there is no activity on buss. Tried disconnecting ABS, no ... Trouble codes: U0102, U0101 |
View | |
| 2007 Dodge Durango Limited 5.7L abs module VIN: 1D8HD58287 Hi every body, I have this durango that initially came, with air bag light, check engine light, abs, esp, and ALL other lights on, when scanned, found multiple codes related to lost communication with FCM, on most of the modules. ABS system showed C121C To... |
View | |
| 2011 Jeep Compass 2.4L Wont move. goes into limp mode. VIN: 1J4NF1FB5B Vehicle came in with a limp in mode. First I pulled codes and I had the above codes. I next checked the fluid and it was a little low but not bad so i topped it off.The fluid did look o.k. I cleared the codes and went for a test drive. It slipped at first ... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers |
