× Auto Repair Pros Member Benefits TechHelp Knowledge Base Forums Resources My iATN Marketplace Chat Pricing About Us Join Industry Sponsors Video Members Only Repair Shops Auto Pro Careers Auto Pro Reviews
Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for July 17, 2018
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2013 Chrysler 300 S 5.7L temp, recirc VIN: 2C3CCABT6D
Customer complains of cool not cold air and recirculate light flashes and grayed out on display. Car has dual zone auto temp control. Pulled NO codes on any module. Put gauges on system and low 50 high 240 at idle in 78 deg shop, temp set to full low. Evac...
View
2003 Dodge Ram 1500 Laramie 4.7L No Start VIN: 1D7HU18N83
Will crank, start and die immediately 3 times or so and then “no Crank”, cycle key and continues to start /die. Theft system is enabled. Scan for codes. SKIM module- Stack overflow error, Rolling code failure, PCM status fault PCM -No Codes, good communica...
View
2004 Dodge Sprinter 2500 2.7L battery dead VIN: WD5PD64474
Problem is ECM power relay staying on or coming on its own (intermittently) and draining battery due to EGR and other engine components staying on. If ECM is disconnected or if relay is removed draw will stop. This is what I can not figure out, if both (ha... Trouble codes: P1926
View
2005 Dodge Sprinter 3500 2.7L Shifts at high RPM VIN: WD0PD54485
Customer says the vehicle use to go into limp mode. Since he replaced the EGR valve it no longer goes to limp mode. Current issue is now that transmission shifts at higher RPMs and I'm thinking it's relative to boost pressure. This van is a real frustratin... Trouble codes: P2511 (EGR valve signal circuit short to ground), P2355 (EGR Flow Rate is too Slow), P2359 (Boost Pressure too Low)
View
1988 Jeep Cherokee 4.0L fuel backs up filler VIN: 1JCMU731XJ
This started with cylinder head replacement, after that poor performance, fuel pressure was 10 psi low. replaced the pump. runs fine. But when adding fuel, at 1/4 tank it will back up the filler neck and shut station pump off. Replacement of fuel pump and ...
View
2002 Jeep Grand Cherokee Laredo 4.0L Front differential ring gear VIN: 1J4GW48S72
Question for experienced differential builders! I replaced the front pinion bearing due to being loose. I re-installed all original shims after replacing the bearing, to check specs, before anything else. Performed contact pattern test with contact patte...
View

Fixes & Summaries for Chrysler
Fix/Summary Answers
2010 Chrysler Sebring Touring 2.4L Cuts out, Stall VIN: 1C3CC4FB9A
I want to thank everyone for their input and advise. I'm closing this without a fix, I may open another one back up if I need to. This is one of are used cars and I only work on it in my spare time so I haven't got to put a lot of time in it yet. Thanks.
14
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next