 Prev |
Professional Automotive Repair Technical Discussions for June 25, 2018 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 2005 Nissan Quest 3.5L Poor Idle Quality, Stall, No Power at all VIN: 5N1BV28U45 Hi guys I have this Van here that I ended up buying from the customer and would like to get running really quick so I can use it for a dayley driver. This Van had been at the dealers and 2 independent shops to try and get it going to no avail. It finally m... Trouble codes: P0011 (p0021-), P0021 (testing and results) |
View | |
| 2011 Nissan Juke SV 1.6L Cuts out, No acceleration VIN: JN1FANF15U Hello techs, Thanks for your help in advance. This car was towed after having a minor mishap of the front wheels dropping into a concrete drainage canal. It seemed like no big deal for the client to have a few people help push the car out and be on her roa... Trouble codes: P2101 (Electric Throttle Control Function Bank 1), C1130 (Engine signal) |
View | |
| 2008 Subaru Tribeca 3.6L HVAC Control Panel VIN: 4S4WX91D18 Curious if any Subaru folks have run into these HVAC controls being blank. On this 08 Tribeca, the radio powers up (display in dash above controls) and you can change volume, station etc. with radio controls in the center panel, which contains the radi... |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 2008 Hyundai Santa Fe GLS 2.7L cvvt VIN: 5NMSG13D48 MY SUSPICIONS WERE RIGHT! THANKS TO DAN AND CALEB-TRUE HELP, THEY FOUND THE MARKS ON THE CVVT ACTATORS ON THE BACK OF ENGINE, TIMING CHAINS RAISED BOSS STRAIGHT UP ON AND THE OTHER @40 DEGREES OFF, (SHOULD ALSO BE STRAIGHT UP) NEEDS NEW ACTUATOR, VERY EXPENSIV... |
8 | |
| 2006 Subaru Impreza WRX 2.5L MIL Lamp on VIN: JF1GG79686 ok so i lab scoped the tumble valve wires at the pcm key cycled on found a one cycle 12v square wave on the blu yel wire(valve close) and multiple 12v square waves on the blue wire at the pcm and at the valve i was only getting a 1-2 volts non square wave at t... Trouble codes: P1096. |
2 |
