 Prev |
Professional Automotive Repair Technical Discussions for April 20, 2018 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 1987 Ford Ranger STX 2.9L no reverse ok im not a transmission guru but do rebuild a few.i recently rebuilt this one with a total rtebuild kit including remman valve body .It has no reverse engagagement at all. I did test drive and all other gears seem fine. i did remove pan and check reverse ... |
View | |
| 2007 Ford F-250 Super Duty XLT 6.0L No Start, Stall VIN: 1FTSW21P47 Please help! Most of the time this truck does not start. When it does start it lasts for anywhere between 10 seconds and 10 minutes. FICM voltages are good, ICP is good. FICM SYNC is always NO when not starting/cranking. Initally had cam and crank sensor c... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 2009 Ford F-150 STX 4.6L Check Engine Light VIN: 1FTRX14W59 A new PCM fixed the issue. Thanks all for being there to help. Trouble codes: P0403 (EGR Control Circuit). |
6 | |
| 2011 Ford F-350 Super Duty King Ranch 6.7L PMI update VIN: 1FT8W3BT3B I was not going to close this, just update, but it left me no choice. The findings are done. This unit does not have a PAD, but the loom is there, Green wire. It is not shorted to ground, has a floating Ohms reading in the thousands. Access to the RCM, it has ... |
7 | |
| 2011 Ford F-350 Super Duty XL 6.7L MIL Lamp on VIN: 1FDRF3HT2B Thank you for the replies but unfortunately the customer never brought it back for us to try to fix it. If and when we get it back, I will post a better answer. Trouble codes: P2269, P1140. |
3 | |
| 2013 Ford F-150 FX4 3.5L Recirculation Door VIN: 1FTFW1ET1D Thanks to everyone for their response. The dash did have to come out, but I got the top of the heater box out that the recirc door sits in without pulling the heater box. You will need a short 8mm box end wrench to do it. The vehicle had an aftermarket radio a... |
8 |
