 Prev |
Professional Automotive Repair Technical Discussions for January 17, 2018 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 2002 Ford E-350 Super Duty 5.4L L/S Brakelight/turnsignal VIN: 1FDWE35L82 I would like to thank all ahead of time for taking time out from your busy schedule to help me out. Here is my problem. I have this here 02 Ford E-350 box truck that has a problem with the tailights on the left hand side.When I started,it had nothing on th... |
View | |
| 2011 Ford F-250 Super Duty King Ranch 6.7L Calipers VIN: 1FT7W2BT2B Vehicle came in last month for brake noise. Found the LF pads were metal to metal the right side pads were considerably thicker still. We had replaced the pads and calipers and machined the rotors 4 months and 14k miles ago (customer goes cross country a l... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 2012 Ford F-150 XL 3.5L Surge, Misfire VIN: 1FTFX1ET2C Unfortunately I have not fixed this vehicle, customer picked up and wasn't overly concerned, as this was an intermittent problem. Forcing low side pump to run at 100%, vehicle ran great, and pump was able to supply full pressure and volume. I'm not sure if I h... Trouble codes: P0087. |
4 | |
| 2012 Ford Edge Limited 3.5L brake pedal VIN: 2FMDK4KC4C Thank you all for your help. As I said, I did ABS bleeds, And wondered how a bad booster could have a low pedal, which I still wonder because I have never seen that happen, hard pedal but never low pedal. I pinched off the ft. brakes which brought up the pedal... |
15 | |
| 2015 Ford Transit Connect XLT 1.6L Surge VIN: NM0LS7FX0F The fix was to replace the "Boost regulator Valve" near the turbocharger and controls the waste gate actuator on the turbo. I tested the "waste gate" actuator with pressure pump and gauge and it was fully open at 10psi and held pressure. Then I eliminated the ... |
3 |
