 Prev |
Professional Automotive Repair Technical Discussions for May 31, 2017 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 2006 Ford Expedition Limited 5.4L drivers door lock switch VIN: 1FMFU20556 This is my personal rig. The drivers door will not unlock with the drivers switch. But will lock It will unlock with passenger door switch. Also it will unlock with the key pad and remote on key ring. If drivers door is open with key in ignition, it will auto ... |
View | |
| 2008 Ford F-550 Super Duty XLT 6.4L mode actuator VIN: 1FDAW57R28 This truck came in with air flow only out of panel. We looked down the defrost vents with a bore scope and could see several sets of ear plugs in the box. We removed the hvac box and cleaned ear plugs, tube of chapstick and a bolt. Cleaned evaporator and heate... |
View | |
| 2010 Ford Explorer Sport Trac XLT 4.6L Unknown VIN: 1FMEU5B87A speedo and tach guages will flutter up and down just a 1/8 of inch up and down when key is turned of. trucks runs great otherwise. Something to worry about or not? No codes at all in the IPC I dont have a clue where to begin diagnosis other than send the clust... |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 2002 Ford Explorer XLT 4.0L Engine VIN: 1FMZU73E62 Going to close this request. My suspicion is a bearning in the jack shaft or balance shaft. All roller rockers are in place. The chains are tight. Yes all tensioners new, and are tight. No signs of anything touching timing cover. With chains exposed, no noise... |
16 | |
| 2014 Ford Taurus SHO 3.5L no assist VIN: 1FAHP2KT2E THANKS FOR YOUR TIME GUYS- DAVE BWAS RIGHT- DEALER ONLY DIAG AT THIS POINT! GREG H |
5 | |
| 2011 Other Ford MV-1 4.6L No Start, Stall VIN: 523MF1A67B Thanks for all the suggestions. The problem turned out to be a short in the Can Bus network internally in the Automatic Level Control module which is under the rear of the van in a nasty location. I connected the two Can plus terminals together and the two can... |
6 |
