 Prev |
Professional Automotive Repair Technical Discussions for March 30, 2017 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 2005 Mazda 3 S 2.3L Engine VIN: JM1BK14355 This Mazda needs extra cranking time when hot. Happens once or twice a day, we could not reproduce the symptom. Customer had fuel pump relay replaced (we did not check this). Based on mileage and the fact that it wasn't holding the pressure we replaced the fue... |
View | |
| 2003 Subaru Forester X 2.5L MIL Lamp on VIN: JF1SG63693 does any one know where the fuel tank pressure sensor is located on a 03 subaru forester? I have looked at the tank, at the canister, in the quarter panel and can't find it any where. Alldata doesn't give any idea where it is and I couldn't find it on the inte... |
View | |
| 1998 Toyota Land Cruiser 4.7L Stall, MIL Lamp on VIN: JT3HT05J9W Hello, We are struggling with this vehicle that came in originally with a intermittent check engine light and no symptoms.The code was a PO171, lean bank one.We smoke tested with no leaks.The tech performed a volumetric efficiency test and he could not get it ... Trouble codes: P0171 |
View | |
| 2007 Toyota Prius Touring 1.5L No Start, Stall, MIL Lamp on VIN: JTDKB20U67 Toyota Tech, please help on this bad boy here. Car tow in 2 months ago. Customer concern engine stall out during accelerate going uphill & not able [...] restart. Found starter battery totally dead. We charge up & still not hold charge. Replace battery & perform ... Trouble codes: P0A90 |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 2005 Mazda RX-8 1.3L engine VIN: JM1FE17N55 put in used engine 10 replies some said out top and some said out bottom ,could have done it either way but decided out bottom. removed driveshaft then trans ,then unbolted cradle onto jackstands,was very easy job ,just double check wiring harness and replace ... |
10 |
