× Auto Repair Pros Member Benefits TechHelp Knowledge Base Forums Resources My iATN Marketplace Chat Pricing About Us Join Industry Sponsors Video Members Only Repair Shops Auto Pro Careers Auto Pro Reviews
Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for April 4, 2016
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2005 Dodge Ram 3500 SLT 5.9L Bank 2 High/Low VIN: 3D7MR48C25
followed all trouble shooting steps for harness/injectors. ohm'd circuit from ECM connector, checked for short to ground on power and signal wires, checked injector terminals for short to ground. all tests were within specification. p2149 for bank 2 high/low ....
View
2005 Dodge Magnum SXT 3.5L converter VIN: 2D4FV48V35
Vehicle has a bad vibration in the driveline above 60 mph that is throttle sensitive. We removed the driveline to replace a loose center support and found the center u-joint to be stiff so we ended up replacing the driveshaft with a new unit. The upper differe...
View
2015 Dodge ram 6.4L Trailer brakes
He has another truck that the same trailer works fine, he brought it in to me and we tested it. It's dual axles and the brakes worked on all 4 wheels. I did an ohm test on the brakes from the plug to ground and it measured 130 ohms. The dealer told him the t...
View
2001 Jeep Wrangler Sport 4.0L No Start, No PCM communication VIN: 1J4FA49SX1
Vehicle was towed in for a non-start. Found it cranks and displays a crossed out key symbol on dash, which is lit solid not flashing. Tried to scan computer for codes, but have no communication. Checked 5v sensor circuit, had 4.5v. Unplugged all sensors and vo...
View

Fixes & Summaries for Chrysler
Fix/Summary Answers
2008 Dodge Ram 1500 SXT 5.7L etc. VIN: 1D7HU18218
To fully explain I had balanced both sets of tires and tried with both sets on the truck. Drove truck with rear driveshaft removed. Drove truck with front half shaft removed in 2wd (therefore transfer case is not engaged and the front drive shaft is not turnin...
13
2010 Dodge Ram 1500 SLT 4.7L abs VIN: 1D7RV1GP5A
Sorry for the delay in closing. Found a pigtail had been wired in previously and the wires were reversed causing this issue. Thanks for all suggestions!
6
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next