 Prev |
Professional Automotive Repair Technical Discussions for March 13, 2010 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 1997 Chrysler Cirrus LX 2.5L Poor Idle Quality, Cuts out, Stall, MIL Lamp on VIN: 1C3FEJ56HO this car came in for a water pump leak.Changed water pump,timing belt,started for warm up went to move car and just stalls,checked codes found throttle position&map sensor codes,Changed both ,still have codes and stalling problem. Trouble codes: 106 (throttle position sensor), 122 (throttle position sensor), 120 (map sensor) |
View | |
| 2006 Chrysler 300 C 5.7L No Start, Cuts out, Stall VIN: 2C3K63H56H Customer came in a week ago, with a compliant that Check engine light and a light that resembles a lighting bolt came on also.Then car died he was sitting in a drive thru when this happened. Waited a few minutes the car started and drove it to our shop. Hooked... |
View | |
| 1992 Dodge Dakota 5.2L No Start Owner replaced the bad V6 with engine and transmission from a wrecked 2000 Dakota with a 5.9L engine. I was asked to figure out why it won't start. He used some wiring form the 92, the entire engine harness from the 2000 and a front end harness he thought was ... Trouble codes: P0463 (Fuel level sending unit volts too high), P1493 (Ambient/battery temperature sensor volts too low), P1687 (No cluster bus messages) |
View | |
| 1998 Dodge Ram 2500 5.9L No Start VIN: 3B7KF26Z5W I'm Thinking PCM On This One But Will Run It By You Just Incase I'm Missing Something. I Guess The No Start Occured After New Inner Fenders Were Replaced. Wonder If Something Didn't Get Shorted When Hooking Things Back Up. The ASD Relay Isn't Working Or Is The... |
View | |
| 2006 Dodge Dakota SLT 4.7L steering column VIN: 2006DAKOTA The truck has an odd creaking noise in the steering column.The clock spring has been replaced with a new oem unit.The original clockspring was worn thru on the top edge.This creaking noise is still there after reassembling and testing.Nothing seems out of the ... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 1997 Dodge Dakota Sport 3.9L Hesitation, Surge VIN: 12H3H3INFH Thanks everyone, I found the issue. It was a sync issue. I pulled the distributor out and it looked like it had been recently replaced, but not adjusted. I used the drb3 and done the sync procedure and now it runs great. thanks everyone Trouble codes: P0300, P0301 (cylinder 1 misfire), P0303, P0305. |
11 | |
| 2006 Dodge Charger Daytona R/T 5.7L Cuts out, Stall First of all, a heartfelt "Thank You!" to everyone that took the time to reply. All of the replies were very useful and even the ones that didnt lead to a fix certainly taught me a great deal. FWIW... when I was thinking that the radio and wiring might be the... Trouble codes: U0100 (TCM loss of communication with PCM/ECM). |
13 | |
| 2000 Jeep Grand Cherokee Limited 4.7L Surge VIN: 1J4GW58N8Y All the responses were great. I ckd the TPS like many of you suggested. I used an analog volt meter to see if there were any dropouts and none showed up that I could see. So I went to the ohm setting and then you could see some faults. I also used a scope to s... Trouble codes: P204&. |
13 | |
| 2006 Jeep Grand Cherokee Laredo 3.7L No Start, Stall VIN: 1J4GR48K36 We fixed the Jeep. As encouraged by all whom replied, we tested the cam and crank signals at the sensor and PCM, all good. Yes, during the failure the tach registered and it showed rpm on the scanner. Found that the ignition coil ground, PCM controlled, was go... |
4 |
