 Prev |
Professional Automotive Repair Technical Discussions for April 15, 2007 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 2003 Honda Civic Hybrid 1.3L no idle stop VIN: JHMES966X3 This vehicle will most times not idle stop,maybe once or twice a day will it work. Sometimes at a light it will idle stop after sitting like it should in stop and go traffic. I have tried with the climate control off or in economy and doesn't make any differen... |
View | |
| 1996 Nissan Maxima GLE 3.0L Poor Idle Quality, Surge VIN: JN1CA21D4T hi group hope someone out there can help. this maxima is driving me nuts, replaced the motor with a used unit, once started it ran poor it would cut out at about 2500 rpm, found problem to be water in the cam sensor connector, then it would surge under light t... |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 2003 Honda Element EX 2.4L transmission/differential VIN: 5J6YH28533 All is good. We changed the rear diff fluid and drove about 10 real tight figure eights and noise/vibration is gone. Thanks all We were pretty sure what to do but it is nice to have other input on some problems Mike |
22 | |
| 1999 Infiniti G20 2.0L ac control thanks for all your replies.mark you were right on the button.this car was missing ambient sensor (bodyshop probably tossed it) |
3 | |
| 2004 Mitsubishi Endeavor Limited 3.8L Mechanical VIN: 4A4MN31964 thanks to Shawn Rollins + Jason [...]. Shawn called my cell # with in hour of posting help message.he all so had to pull engine due to accident, and had difficulty removing due to axle shaft being force deeper into trans from impact. in his case trans was... |
2 | |
| 2000 Nissan Pathfinder LE 3.3L drivability VIN: JN8AR07S1Y Thanks for all the repies the rear upper and rear lower control arms were the problem even though the had very little movement on the rack. We opted to replace the complete arms to speed the repair process. Thanks again for all the responses. |
11 |
