|
2013 Jeep Wrangler Unlimited Sahara 3.6L Stays in Limp Mode After Repair
Customer came in , no shift , in limp mode PO743 TCC solenoid. replaced TCC solenoid & circuit board assembly. old one had 1.2 Ohns (spec is 2.5) ohmed wiring from TCM (ohms 3.2 cold) cleared code. comes back after test drive, still stuck in limp mode. Is ...
FIX posted 6/11/2021
iATN Members:
Login to view full TechHelp request Auto Repair Pros: Join iATN to read this TechHelp request Vehicle Owners: Find a nearby iATN member to repair your vehicle 13 Replies Received (View Replies)13 Replies Received (Hide Replies)
|
Message Closed
|
13 Replies Received
13 Replies Received
Related Documents & Media | VIN | 1C4BJWEG0D |
| Engine | 3.6 L / 6 cyl / GAS |
| Trans | 5-speed Automatic (Electronic) |
| Delivery | Fuel Injection |
| Affected | Stays in Limp Mode After Repair |
| Conditions | No Shift |
| Misc. | Nag 1 |
Message Closed
Vehicle Data
2013 Jeep Wrangler Unlimited Sahara
| VIN | 1C4BJWEG0D |
| Engine | 3.6 L / 6 cyl / GAS |
| Trans | 5-speed Automatic (Electronic) |
| Delivery | Fuel Injection |
| Affected | Stays in Limp Mode After Repair |
| Conditions | No Shift |
| Misc. | Nag 1 |
Video