 Prev |
Professional Automotive Repair Technical Discussions for November 2, 2021 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for European
| Help Request | Answers | |
| 2013 Audi S4 3.0L Poor Idle Quality, Misfire VIN: WAUKGAFL2D Test drove and engine ran good. Scanned for codes, none in system. Checked obd2 and there wasn't any stored, pending or premiant codes in that either. Air filter is a bit dirty, spark plugs appear to be in good condition. Engine shakes a little on start up... Trouble codes: P0306, P130A |
View | |
| 2014 Land Rover LR4 HSE 3.0L MIL Lamp on VIN: SALAK2V64E Greetings,Have the lean codes for bank 1 and 2.At idle,short term fuel is 2,long term 45,both banks.Clear adaptions to zero,short term immediately appreciates to 20%,long term zero eventually increasing back to 45,very quickly,about 2 minutes.Smoked intake... Trouble codes: P2187 (Bank 1-too lean), P2189 (Bank 2-too lean) |
View | |
| 2008 Volvo XC70 3.2 3.2L MIL Lamp on VIN: YV4BZ982X8 vehicle came in with MIL lamp illuminated pulled codes P0012-00/P0012-68 intake camshaft position timing over retarded bank 1. P151B-68 idle speed control Rpm lower than expected. P0300 random misfire. Vehicle runs fine wondering if anyone has ran into thi... Trouble codes: P0120, P0126, P151B, P3000 |
View |
Fixes & Summaries for European
| Fix/Summary | Answers | |
| 2003 Aston Martin DB7 GTA 6.0L Code VIN: SCFAB42343 THIS HEADACHE IS FIXED. I DROVE ANOTHER 67 MILES AND ENGINE TROUBLE CODE P0171 OCCUR. I FOUND A CRACKED PCV T-FITTING HOSE IN THE REAR OF THE ENGINE .INSTALLED NEW PCV HOSE HARNESS AND ALL OBD MONITOR INDICATE READY AFTER DRIVING FOR 438 MILES. THANKS FOR TH... |
2 | |
| 2003 Volkswagen Passat GLS 1.8L Shift performance VIN: WVWVD63B43 Thanks for the advice. I had actually begun inspecting those splices last night before I got your reply. I tugged on the wires and removed the tape from the splices and after inspecting them I thought they appeared okay. After reading your response I decided t... |
2 |
