
![]() |
Professional Automotive Repair Technical Discussions for April 29, 2021 International Automotive Technicians' Network (iATN) - Members Only |
Next ![]() |
(Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. |
Open Help Requests for Chrysler
Help Request | Answers | |
2010 Dodge Ram 1500 SLT 5.7L Starter VIN: 1D7RV1CT0A I suspect I may have a bad PCM, but might also be a grounding issue. I never see 12v at the relay on the coil side. The switch side is fine and jumping the relay will crank the starter. I question weather or not the TIPM might be acting up as well, but .6 ... |
View | |
2010 Jeep Patriot Sport 2.4L Misfire VIN: 1J4NT2GB6A This is a weird one for me. The PCM says the engine is misfiring on cylinders 1 and 4, but it's running fine. Then because the PCM "thinks" it's misfiring, it shuts the injectors off on those cylinders, and then the engine actually starts to misfire. Turn ... Trouble codes: P0300 (Random misfire), P0301 (Cylinder 1 misfire), P0335 (Crank sensor circuit malfunction), P0315 (Crank position sensor not learned) |
View | |
2013 Jeep Wrangler Unlimited Sahara 3.6L stays in limp mode after repair VIN: 1C4BJWEG0D Customer came in , no shift , in limp mode PO743 TCC solenoid. replaced TCC solenoid & circuit board assembly. old one had 1.2 Ohns (spec is 2.5) ohmed wiring from TCM (ohms 3.2 cold) cleared code. comes back after test drive, still stuck in limp mode. Is ... |
View |
Fixes & Summaries for Chrysler
Fix/Summary | Answers |